Panasonic AJ-D950 VCR User Manual


 
USER menu
<BASIC>
Item
No.
Superimposed
display
000
P-ROLL
TIME
001
LOCAL
ENA
002
TAPE
TIMER
003
REMAIN
SEL
00
4
SETUP
NUMBER
00
5
METER
SEL
006
SYNCHRO-
NIZE
00
7
SUPER
008
DISPLAY
SEL
Setting
No.
Superimposed
display
OS
5S
15S
DIS
ST&EJ
ENA
Description
0000
0005
0015
0000
0001
0002
0000
0001
0000
0001
0000
0001
0000
0001
0000
0001
0000
0001
0000
0001
0002
This sets the preroll time which can be set from 0 to 15
seconds in 1 -second increments.
<Note>
When the unit is set to automatic editing [PREVIEW, AUTO
EDIT], the unit will not operate if the preroll time is set to 0
seconds.
This selects the buttons which can be operated on the front
panel when the REMOTE/LOCAL switch has been set to
REMOTE.
±12h
24h
OFF
ON
OFF
ON
CUE
VIDEO
OFF
ON
OFF
ON
TIME
T&STA
T&S&M
0: No buttons can be operated.
1: Only the STOP and EJECT buttons can be operated.
2: All buttons except for the RECORDER and PLAYER
buttons can be operated.
This selects the 12 or 24 hour display for the CTL counter.
0: 12 hour display
1: 24 hour display
This selects whether the remaining tape time is shown on the
front panel.
0: Not shown.
1: Shown.
<Note>
Even when
Shown
is selected, the remaining tape time is not
shown while the unit is calculating the remaining tape time
after ejecting or inserting the cassette.
This selects whether the SETUP-MENU No. is displayed on-
screen.
0: The SETUP-MENU No. is not displayed.
1: The SETUP-MENU No. is displayed.
This selects whether the level meters are to display the CUE
track signal level or the video signal level.
0: The CUE track signal levels are displayed.
1: The video signal levels are displayed.
This selects whether or not to synchronize between two VTRs.
0: No synchronization. The editing points deviate several
frames, but editing can be started quickly.
1: Synchronization. Allows for error-free editing.
This selects whether the time code and other super display
which are output to the VIDEO OUT 3/SERIAL OUT 3 con-
nector is to shown.
0: Not shown.
1: Shown.
This selects what information is to be provided by the time code
and other super displays output to the VIDEO OUT 3/SERIAL
OUT 3 connector.
0: Time only.
1: Time and status.
2: Time, status and mode.
<Note>
An error message is displayed when an warning or error
occurs.
The underline on the setting item denotes the initial setting.
-47
-