Filter
Top Products
– 51 –
Setup menus
SYSTEM menu
<SYSTEM>
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
00 WFM SEL 0000 CTL
0001 TC
0002 VIDEO
0003 SYNC
0004 RF-L
0005 RF-R
0006 ENV-L
0007 ENV-R
10 ENCODER 0000 REMOTE
REMOTE 0001 LOCAL
SEL
11 SYS SC/H 0000 REMOTE
0001 LOCAL
12 SYS H 0000 –1100
(HD)*1 : :
1100 0
::
2200 1100
13 V PHASE 0000 –500
(HD)*1 : :
0500 0
::
1000 500
14 SYS SC 0000 –108
(SD)*
2
::
0108 0
::
0216 108
The underline on the setting item denotes the initial setting.
*
1
: With the HD output (HD tape playback or up-conversion output)
*
2
: With the SD output (SD tape playback or down-conversion output)
This selects the signal to output from the VIDEO OUT 2
connector.
0: The CTL signal is output.
1: The TIME CODE signal is output.
2: The VIDEO OUT signal is output.
3: The SYNC signal is output.
4: The PB L RF signal is output.
5: The PB R RF signal is output.
6: The PB L ENV signal is output.
7: The PB R ENV signal is output.
<Note>
1. The settings can be changed at any time regardless of the
setup menu item No. 30 (MENU LOCK) setting.
2. The signals which are output during normal playback have
approximately the levels given below.
CTL: 0.1 to 0.3 Vp-p TC: 0.6 Vp-p
VIDEO: 1.0 Vp-p
This selects whether the video output signal is to be adjusted
on the VTR or with the external encoder remote control.
0: Video output signals are adjusted with the external encoder
remote control.
1: Video output signals are adjusted on the VTR.
This sets whether the system phase is to be adjusted using
the unit’s controls or using the external encoder remote
control.
0: The external encoder remote control is used to adjust the
system phase.
1: The system phase is adjusted using the unit’s controls.
<Note>
This setting has no effect when LOCAL has been selected as
the SYSTEM menu item No.10 (ENCODER SEL).
This enables the system phase to be adjusted in 13.5ns steps.
-: The phase is advanced.
+: The phase is delayed.
<Note>
If setting
operation is performed, the setting value does not
return to factory (default) setting.
This enables the video system phase to be adjusted in 27ns
steps.
-: The phase is advanced.
+: The phase is delayed.
<Note>
In the case of the HD up-converter output from the SD
playback tape (when the option has been installed), the video
phase is fixed.
This enables the system phase to be adjusted in a total
variable range of +/-180 degrees or more.
-: The phase is advanced.
+: The phase is delayed.
<Note>
If setting
operation is performed, the setting value does not
return to factory (default) setting.