Filter
Top Products
– 57 –
USER menu
<OPERATION> (continued)
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
107 EE MODE 0000 NORMAL
SEL 0001 THRU
108 PLAY 0000 0
DELAY
::
0015 15
109 CAP.LOCK 0000 2F
0001 4F
110 AUTO REW 0000 OFF
0001 ON
111 MEMORY 0000 OFF
STOP 0001 ON
The underline on the setting item denotes the initial setting.
This selects the EE mode output signals.
0: Signals are output with a delay equivalent to the length of
internal signal processing.
1: Signals are output directly, without internal processing, and
so are output with no delay.
<Note>
When editing mode is selected, SDTI is selected as the video
input signal (when the optional board AJ-UDC150P has been
installed), or INT SG is selected at either VIDEO or AUDIO, he
internal operations are forcibly set to NORMAL.
This set the play delay time in frame increments.
This selects whether the playback framing is to be locked in 4-
field or 2-field increments.
0: 2F mode
1: 4F mode
This selects whether to rewind the tape automatically to the
tape start when the tape end is detected.
0: The tape stops at the tape end.
1: The tape is rewound to the tape start.
This selects whether the VTR is to stop automatically when
the counter value reaches “0” during a fast forwarding or
rewinding operation in the CTL mode.
0: The VTR does not stop.
1: The VTR stops automatically.
<Notes>
1. The stop mode concerned is either the stop or the still-
picture (SHTL STILL) mode depending on the setup menu
No. 315 (AFTER CUE-UP) setting.
2. When both the AUTO REW function and MEMORY function
have been selected at the same time, the AUTO REW
function takes precedence.
Memory stop function
REW button
FF button
FF button
REW button
Zero
point
The MEMORY STOP function does not work if it is
activated within a range of 0 ±2 frames.
FWD direction
4
3
1
2
! When the FF button is pressed, the VTR performs the regular fast forward operation since the zero point is not located in the
direction of operation.
@ When the REW button is pressed, the PREROLL lamp lights (the SHTL lamp lights as well), the VTR proceeds with the
preroll operation, and it automatically stops when it reaches the position where the counter reads “0.”
# When the REW button is pressed, the VTR performs the regular rewinding operation since the zero point is not located in the
direction of operation.
$ When the FF button is pressed, the PREROLL lamp lights (the SHTL lamp lights as well), the VTR proceeds with the preroll
operation, and it automatically stops when it reaches the position where the counter reads “0.”
Setup menus