Filter
Top Products
37
1
Select the editing mode on the <ASSEMBLE> or
<INSERT> menu.
2
Select the VTR to be operated by pressing the
RECORDER or PLAYER button.
3
Register the IN and OUT points using the SET
button and IN and OUT buttons. The player’s OUT
point cannot be registered.
4
Press the PLAYER button to select the player
VTR, and then set the initial speed using the
search dial while holding down the SET button.
5
When the SET button and PREVIEW/REVIEW
button are pressed at the same time, the tapes in
both the player and recorder are automatically
prerolled, and the player VTR plays back the tape
at the initial speed setting up to the IN point.
6
After the tape has passed the IN point, turn the
search dial to store the playback speed of the
player VTR in the memory.
7
When the tape passes the OUT point that was set
by the recorder, the storing of the playback speed
in the memory ends.
8
When the AUTO EDIT button is pressed, variable
memory editing is executed. Once editing has
been executed, the memorized speeds will be
cleared except for the initial speed which is not
cleared.
9
By pressing the PREVIEW/REVIEW button, the
edited results can be checked.
Variable memory editing operation procedure
To perform variable memory editing operations, set
this VTR, which is connected as the recorder to the
variable memory mode, and take the steps below.
Variable memory function
<Notes>
• Whatever is stored in the memory will be cleared
when the VTR exits the variable memory mode. It
is also cleared when the POWER switch is set to
“OFF.”
• Phase synchronization is not performed during
playback up to the IN point of the variable memory
editing. Therefore, depending on the VTR used as
the player and its speed setting, no guarantees are
made for the accuracy of the IN point.
• When conducting variable memory editing in the
speed range of
j
1.0
k
to
i
2.0
k
, use VTRs with
which these speeds are guaranteed for both the
recorder and player.
POWER
OFF
ON
HEADPHONES
PUSH
LOCK
FULL
CH CONDITION
MONITOR
FULL/FINE
REMOTE
LR
9P 50P
RS-232C
CH
12345678
CUE
XL/L/M
-
cassette
Do not insert S-cassette
without adapter
EJECT
AUDIO CH SELECT
SHIFT
ABC DEF GHI
JKL MNO PQRS
PREVIEW/
REVIEW
PRE-
ROLL
A IN A OUT
HOME RF1 ASSEM
ADJUST
SHTL
REV FWD
VARJOG
STAND BY
RECORDER INPUT CHECK
PLAYER
SERVO
EDIT PLAY REC
REW STOP FF
REC INHIBIT
PUSH-INTER
INSERT
RF2
VIDEO
UNITY TC CUE
AUDIO
UNITY DIAG MENU
TRIM
SET
IN
OUT
AUTO
EDIT
789
456BS
TUV WXYZ
123
ENT
0CTF
F1 F2 F3 F4 F5 F6
CH
1
CH
5
CH
2
CH
6
CH
3
CH
7
CH
4
CH
8
FULL
REC P8 REC P8 REC P8 REC P8
5
1
8
9
46
2
3