Panasonic EE23 Flat Panel Television User Manual


 
– EE23 –
Design, Specifications are subject to change without notice. Ask factory for technical specifications before purchase and/or use.
Whenever a doubt about safety arises from this product, please inform us immediately for technical consulation without fail.
Aluminum Electrolytic Capacitor/FA
FA
A
Series:
Type :
-55 to + 105°C
6.3 to 63 V .DC
68 to 15000 µ F
±20 % (120Hz/+20°C)
I < 0.01 CV (µ A) after 2 minutes application of rated working voltage at +20°C.
W.V. 6.3 10 16 25 35 50 63
tan δ 0.22 0.19 0.16 0.14 0.12 0.10 0.08
(max.)
(120Hz /+20°C)
Impedance at -10°C, 100KHz <200 % of initial specified value at 20°C,100kHz.
(Impedance ratio at 100kHz)
L
L <16:L+1.0max
φ
0.05
14 min min
φD+0.5 max
φ10<
P±0.5
φD+0.5 max
φ8>
P±0.5
L >20:L+2.0 max
Body Dia. φD
Body Length L
Lead Dia. φd
Lead space P
(mm)
0.6 0.6 0.6 0.8 0.8 0.8
3.5 5 5 5 7.5 7.5
8 10 12.5 16 18
Frequency correction factor for ripple current
W (V.DC)
60 120 1k
10k
100k
Frequency(Hz)
0.55 0.65 0.85 0.90 1.0
6.3 to 63
Cap.(µF)
6.8 to 330
390 to 1000
1200 to 2200
2700 to 15000
0.75 0.80 0.90 0.95 1.0
0.80 0.85 0.95 1.00 1.0
0.70 0.75 0.90 0.95 1.0
E E U F A
< 25 > 30
Discontinued
Radial lead type
Features Endurance :105°C 2000 to 5000h
Smaller than Series HFQ
Low impedance (20 to 40 less volume than
Series HFQ)
Specification
Operating Temp. Range
Rated W.V. range
Nominal cap. range
Capacitance tol.
DC leakage current
tan δ
Shelf life
< ±20% of initial measured value
< 200% of initial specified value
< initial specified value
Capacitance change
tan δ
DC leakage current
Explanation of Part Numbers
Dimensions in mm (not to scale)
Safety vent
Vinyl sleeve
R.W.V. code
N.Capacitance code
Characteristics
at Low Temperature
Endurance
After following life test with DC voltage and +105 ±2°C ripple current value applied (The sum of
DC and ripple peak voltage shall not exceed the rated working voltage),the capacitors shall meet
the limits specified below.
Duration: 2000 hours (φ8), 3000 hours (φ10), 5000 hours (φ12.5 to φ18) Post test requirements at
20°C.
After storage for 1000 hours at +105±2°C with no voltage applied and then being stabilized at
+20°C,capacitor shall meet the limits specified in “Enduramce”.
Product code Series code
Option
Add 0.02 per 1000µF for products of 1000µF or more.
Mar. 2005