Filter
Top Products
[OPTION] menu
ENGLISH - 37
[SXGA MODE]
Sets when the entire image is not displayed while
SXGA is input.
Set it to [SXGA] normally.
1) Press
to select [SXGA MODE].
2) Press
to switch [SXGA MODE].
z
The setting will change as follows each time
you press the button.
[SXGA] [SXGA+]
[SXGA]
When the entire image is
displayed by setting to [SXGA]
[SXGA+]
When the entire image is not
displayed by setting to [SXGA]
[WIDE MODE]
Sets when the image is projected with the aspect ratio
of 4:3 even when the wide signal is input.
1) Press
to select [WIDE MODE].
2) Press
to switch [WIDE MODE].
z
The setting will change as follows each time
you press the button.
[ON] [OFF]
[ON] When inputting the wide signal
[OFF] When inputting the 4:3 signal
[NO SIGNAL SLEEP]
Sets the time to stop the output from the <DIGITAL
LINK> terminal when the interface box detects that no
signal is input to the selected video input terminal.
With this function, the power consumption of the
interface box and the projector can be reduced.
1) Press
to select [NO SIGNAL
SLEEP].
2) Press
to switch [NO SIGNAL
SLEEP].
z
The setting will change as follows each time
you press the button.
[10MIN.] [20MIN.]
[OFF] [30MIN.]
[10MIN.]
Stops output of the signal when
no signal is input for 10 minutes.
[20MIN.]
Stops output of the signal when
no signal is input for 20 minutes.
[30MIN.]
Stops output of the signal when
no signal is input for 30 minutes.
[OFF] Disables [NO SIGNAL SLEEP].
Note
z
This setting is supported only when the DIGITAL
LINK compatible projector is connected.
z
To transfer the user logo to the projector by using
the logo transfer software, turn this function to [OFF]
before transferring. When the output is stopped for
longer than the set time, the communication will be
shut down and there are cases that the user logo
cannot be transferred properly.
z
When output from the <DIGITAL LINK> terminal
stops, output from the <AUDIO OUT> terminal also
stops.