Filter
Top Products
!
!
!
Set the switch to VCR.
Turn on the TV.
then press the button to switch on the VCR/DVD.
VCR/TV/DVD
VCR-Standby/ON
The VCR will now start Auto Setup.
VCR AUTO SETUP
VCR Display
On-Screen Display
Auto Setup
Tuning : Ch 21
- While Auto Setup is running the first digit of the VCR display will flash.
After a while it will stop flashing and the RF output channel number will
be displayed.
-
-
Select an unused channel pre-set on your TV and tune it to the RF
output channel number shown on the VCR display (or until you can
clearly see the Auto Setup screen). Store the new video playback
channel (refer to the instructions for your TV).
If you connect your VCR/DVD to the TV by a Scart cable, you do not
need to tune the TV as described above. Simply select appropriate
input mode on TV.
You can complete the Owner ID now or skip this step and do it later.
To do it later, press the button again. Your VCR is now ready to use.
To set the Owner ID now, press the buttons or to enter a
four-digit PIN number.
Press to correct the digit.
Make sure that you will remember the PIN number (make a note of it).
Press the button twice to confirm.
Enter the [Name], [House No] and [Postcode] in the same way.
Press the button to confirm each entry.
EXIT
Numeric
ENTER
ENTER
!
!
!
!
!
!
!
!
Press the button to leave the Owner ID screen.
You will now see the TV picture. Your VCR is now ready to use.
EXIT
Owner ID
PIN number : 846
*
Name :
**************
House No :
***********
Postcode :
***********
::
:
select
exit
store
ENTER
EXIT
You now have the opportunity
to enter your details and
help the police crack crime
see instruction book.
On-Screen Display
Owner ID
DVD
TV
VCR
16