Filter
Top Products
B
F
B
B
Attaching the pedestal to the display
For setting up the pedestal, refer to the operating instructions of plasma display.
Rear
Attaching the light-blocking panel
1 Prepare the light-blocking panel.
(1) Place the light-blocking panel with the cloth
sheet facing upward.
(2) Fold over the portion of the panel with notches
and holes in it along the crease. (See illustration.)
H
2
1
D F
H
H
Notch
Front
H
C
2
1
2 Attach and secure the light-blocking
panel.
(1) Slightly bend the light-blocking panel to form
a U-shape and fi t the ends into the gaps (right
and left) between the stand pins and the plasma
display. Align the notches in the light-blocking
panel with the stand pins.
• The cloth sheet side should be facing the rear
panel of the plasma display.
(2) Align the four holes in the light-blocking panel
with the holes in the stand base, insert the (four)
fi xing pins , and push down hard on the tops of
the fi xing pins to lock them in place.
Cloth sheet
1 Attach the plasma display to the
pedestal.
Arrow marks are displayed on the back cover at the
locations shown below.
Align the stand pins with these arrows, and install
the plasma display.
2 Attach the stand poles.
(1) Insert the two stand poles into the stand base
from the rear of the plasma display, and then
use the stand pole fi xing screws to secure the
stand poles .
• The stand poles have a front and back.
(2) Use the four stand pole display fi xing screws to
secure the stand poles and plasma display.
4
English