Filter
Top Products
6
English
4. Attaching the insulation spacers to the
display unit
1. Remove the top part of the outer cardboard box used for the
plasma TV unit, and pull the protective bag down.
To ensure that the plasma TV unit does not fall over, provide
support at the front.
2. Remove the accessory box and speaker box from the outer
cardboard box.
3. Remove the four caps from the display unit using a Phillips
head screwdriver.
Phillips head screwdriver
Cap
㇙
㇚
㇛
㇟
Cap
Note
• Keep the caps which have been removed in a safe place.
(They will be required when a separate installation stand is used.)
4. Using the supplied Allen wrench ㇟, mount the 4 Allen head
countersunk screws ㇙, 4 dished toothed washers ㇚ and 4
insulation spacers ㇛ provided at the locations where the caps
were attached, as shown in the figure on the right.
(Tightening torque: 3 to 4 N•m)
5. Connect the HDMI cable (either the one provided or one obtained
separately) to the display unit.
Use the HDMI cable in the length which is appropriate for the
distance from where the tuner unit is to be installed.
Notes
• For details on how to attach the speakers and other parts packed
with the plasma TV unit and to connect the HDMI cable, refer to the
operating instructions of the plasma TV unit.
• When a full Hi-Vision wireless unit is to be used, follow the instructions
given in the unit’s operating instructions.
5. Attaching and securing the display unit
to the wall-hanging bracket
1. Using the positioning stickers adhered to the wall as guidelines,
align the top of the display unit at the left and right.
2. Engage the insulation spacers at the top of the display unit with
the cutouts at the top of the bracket unit, and slowly lower them
into place.
3. While lifting the display unit slightly, insert the bottom insulation
spacers into the holes at the lower end of the wall-hanging
bracket, and then pull the display unit straight down into place.
Cutout at top
Insulation spacer at top
Hole at
bottom
Insulation spacer at bottom
Surface of wall
Surface of wall
2.
3.
CAUTION
• If the plasma TV is lifted too much, its top part will become disengaged
from the wall-hanging bracket.
Fitting procedure