Filter
Top Products
71
When operating the video multiplexer with the WV-CU550C
system controller, the following buttons and keys of the sys-
tem controller correspond with those of the video multiplex-
er.
While the indicator of the [ALT] button is on, control of
the VCR with the buttons shown below is enabled.
: Rewind FUNCTION
: Pause PRE-POSI
: Fast Forward STILL
: Reverse Play CAMERA SET ON A
: Stop EL-ZOOM
: Play CAMERA SET OFF B
: T/L mode C
: T/L mode SET UP D
: Record MULTISCREEN SELECT
Refer to the supplied panel templates for the other but-
tons.
Note: When controlling the multiplexer with the WV-
CU550C, it is recommended to set the LOCK switch
on the WJ-FS616C to the ON position to prevent
false operation.
/
/
FUNCTION OPERATIONS (WITH WV-CU550C)
Controlling the Video Input and
Monitors
To select a monitor and camera, follow the procedure
shown below.
1. Turn on the power of the system controller by pressing
the Controller On/Off Switch located on the rear of the
system controller to the ON position.
The following displays appear on the LCD display.
Select the mode by pressing the Function buttons. The
buttons operate as shown below.
F1: Same operation as MULTISCREEN button
F2: Same operation as SPOT button
F3: Same operation as SEQUENCE button
F4: Same operation as VCR/CAM button
_ Mode OFF
✽ MODE ON
2. Set the LCD display to ✽SPOT or ✽MLT by pressing the
[F2] or [F1] button on the controller.
The indicator on the LCD display indicates the selected
monitor.
3. Select the desired camera number by pressing the
Numeric keys, then press the [CAM(SET)] key.
The selected camera image is displayed in single spot
on the selected monitor screen.
Note: Proceed as described for Controlling the Video
Input and Monitors on page 48 to 55.
Direction Button
LEFT
RIGHT
UP
DOWN
HOME/SET
Joystick Controller
LEFT RIGHT
UP
DOWN
Camera Selection Buttons
4
8
12
16
3
7
11
15
2
6
10
14
1
5
9
13
CAMERA/PRESET POSITION
Numeric Key + Set Key
1 2 3
4 5 6
7 8 9
MON CAM
UNIT/ESC
0
SET
F3 F4F2F1
U01 C01
_
MLT ∗SPOT
_
SEQ
_
VCR
1 2 3
4 5 6
7 8 9
MON CAM
UNIT/ESC SET
0
Unit Number
Camera Number
(“Mlt”or “Seq”)
Playback, PRE-POSI,
STILL, camsetup