Pelco C237M TV Mount User Manual


 
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
1. Installation and servicing should only be done by qualified service and installation per-
sonnel.
2. Installation shall be done in accordance with all local and national electrical and mechani-
cal codes utilizing only approved materials.
3. Use only installation methods and materials capable of supporting four times the maxi-
mum specified load.
4. Use stainless steel hardware to fasten the mount to outdoor surfaces.
The product and/or manual may bear the following marks:
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.
DESCRIPTION
The MRWA Wall Mount is designed for indoor use with pendant-mount domes and monitor
mounts which utilize a suitable length of 1.5-inch NPT threaded pipe for mounting.
The MWRA mount is compatible with MR3000/MR3050/MR4050 monitor mounts and most
Pelco pendant domes.
INSTALLATION
1. Determine the location for mounting your specific equipment on the wall. Remember to
allow for adequate clearance on all sides to insure proper operation of selected equip-
ment.
2. Use the mount itself as a template to mark the required mounting holes (a minimum of six
fasteners must be used).
3. Using the fasteners of a suitable size, attach the mount to the chosen surface.
4. Attach the chosen equipment to the MRWA mount using a suitable length of threaded
1.5-inch NPT pipe. Tighten set screw as shown in Figure 1. Remember to be certain that
the mount is properly fastened to a surface adequate to support the total weight of the
mount and equipment.
C237M (3/99)
MRWA
Wall Mount
300 W. Pontiac Way,
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel (1-559) 292-1981
FAX (1-559) 348-1120
www.pelco.com
®
This symbol indicates that danger-
ous voltage constituting a risk of
electric shock is present within
this unit.
This symbol indicates that there
are important operating and main-
tenance instructions in the litera-
ture accompanying this unit.
CAUTION:
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
NOTE:
When determining the
mount location, consideration
must be given to the total weight
of both the mount and the equip-
ment selected for use with the
mount.
The mounting surface must be
adequate to support this total
weight.
LISTED
U
L
®