Filter
Top Products
C279M-A (1/03)
EA4348
Mount Adapter
Figure 1. Attaching EA4348 Adapter
Pelco World Headquarters • 3500 Pelco Way • Clovis, California 93612 USA • www.pelco.com
USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150
International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
1. Installation and servicing should be done only by qualified service personnel and conform to all local codes.
2. Installation shall be done in accordance with all local and national electrical and mechanical codes utilizing only approved materials.
3. Use only installation methods and materials capable of supporting four times the maximum specified load.
4. Use stainless steel hardware to fasten the mount to outdoor surfaces.
DESCRIPTION
The EA4348 is designed to allow the Esprit
®
Wall Mount (EWM) to mount to PP4348 and PP300L/PP301L parapet adapters or to adapt existing
Legacy
®
style mounts for use with Esprit systems.
The EA4348 is compatible with the following Pelco adapters:
CM400 Corner adapter
PA402 Pole adapter
PP300L, PP301L Parapet corner adapters
PP400 Parapet wall adapter
PP4348 Parapet rooftop adapter
INSTALLATION
1. If installed, remove the Spectra/Legacy mount from the Spectra/Legacy
adapter.
2. Attach the EA4348 adapter to the Legacy/Spectra adapter with the flat
washers, split lock washers, and nuts that are provided. Refer to Figure 1,
which shows the EA4348 adapter and the PA402 pole adapter.
3. Place the EWM mount over the studs on the EA4348 adapter.
4. Fasten the EWM mount to the EA4348 adapter with the flat washers, split
lock washers, and nuts that are provided.
®
PA402
EA4348