Filter
Top Products
DESCRIPTION
This manual covers the installation of the LB1000MT mounting brackets necessary for wall
mounting the LB1000/LB1012/LB1000DC VCR Lock Box.
Please make sure your LB1000MT kit contains the following parts:
1 LBMT104001COMP – Right-side wall mount bracket
1 LBMT104002COMP – Left-side wall mount bracket
4 ZH1/420X.375SPP – Screws for securing mount to lock box
4 ZH1/4LWSIS – Internal lock washers
INSTALLATION
The LB1000MT kit is designed for wall mounting the LB1000/LB1012/LB1000DC horizontal
VCR lock box. All necessary hardware for mounting the support brackets to the lock box has
been provided.
To install the LB1000MT mounting brackets, perform the following steps:
1. For adequate room and ease of handling, remove the VCR unit from the VCR lock box
before installing the mounting brackets to the lock box.
2. Remove the rubber feet from the bottom of the lock box – notice the set of mounting
holes located next to the rubber feet holes in the bottom of the lock box. This inside set of
holes will be used in installing the mounting brackets.
3. Line up the PEM nuts in the LB1000MT wall bracket with the holes in the bottom of the
lock box. Install as shown in Figure 1, using the provided screws and lock washers to
securely install the lock box to the mounting brackets.
4. Make sure the bracket has been securely installed.
5. Mount the combined lock box and mounting bracket unit to the wall surface. (See note.)
6. Make sure the wall mount is secure. Mount the VCR into the lock box and make all nec-
essary connections.
C292M-A (3/00)
LB1000MT Wall Mount for
LB1000/LB1012/LB1000DC VCR Lock Box
3500 Pelco Way,
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel +1 (559) 292-1981
FAX +1 (559) 348-1120
www.pelco.com
NOTE:
Because wall surfaces
differ, the necessary hardware
for mounting the unit to the wall
has not been supplied.
CAUTION:
Use only appropri-
ate and securely-fastened
mounting bolts for mounting the
unit to a wall. The combined
weight of the LB1000/LB1012/
LB1000DC lock box, LB1000MT,
and an average VCR can easily
exceed 60 pounds (27.18 kg).
When properly installed, the
LB1000MT provides a 16-inch
spread to the mounting hole pat-
tern, allowing for the brackets to
be securely mounted to stan-
dard wall studs.
Figure 1. LB1000MT Wall Mount Installation