Pelco MM1000 TV Mount User Manual


 
C240M-D (3/00)
MM1000 & MM2000
Monitor Mounts
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
1. Installation and servicing should only be done by qualified service and installation personnel.
2. Installation shall be done in accordance with all local and national electrical and mechani-
cal codes utilizing only approved materials.
3. Use only installation methods and materials capable of supporting four times the maxi-
mum specified load.
4. Use stainless steel hardware to fasten the mount to outdoor surfaces.
5. To prevent damage from water leakage when installing a mount outdoors on a roof or
wall, apply sealant around the bolt holes between the mount and mounting surface.
The product and/or manual may bear the following marks:
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.
DESCRIPTION
PELCO’s MM1000 wall mount for vertical mounting and MM2000 pedestal mount for horizontal
mounting are designed to hold a 9-inch or 12-inch CCTV monitor weighing up to 40 lb (18 kg).
These mounts are also suitable for mounting other devices such as speakers.
INSTALLATION
1. Drill holes in the mounting surface ac-
cording to Figure 1 and attach the mount
securely with suitable fasteners of mini-
mum 1/4-inch diameter (not supplied).
2. Remove the rubber feet from the bottom
of the monitor. Place the monitor on the
monitor support pan and secure the
monitor to the pan. (The screws previ-
ously used to secure the rubber feet to
the bottom of the monitor may be used.)
3. If the monitor mounting hole pattern
does not align with slots in support pan,
use extension brackets provided and
attach them to monitor base (see Fig-
ure 2). Then place monitor and brack-
ets onto support pan and tighten nuts
(provided) to secure monitor.
4. To adjust pan rotation (360 degrees),
loosen cap nut or hex head bolt. Set in
desired direction and tighten cap nut or
hex head bolt. To adjust tilt angle of
monitor support pan (MM1000 adjusts
10 degrees up and 90 degrees down;
MM2000 adjusts 45 degrees up or
down), loosen hex head bolts. Lock in
desired angle position by tightening hex
head bolts.
This symbol indicates that there are important operating and maintenance instruc-
tions in the literature accompanying this unit.
3500 Pelco Way,
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel +1 (559) 292-1981
FAX +1 (559) 348-1120
www.pelco.com
4.75
(12.06)
1.50
(3.81)
0.75
(1.91)
2.84
(7.21)
HOLE PATTERN MM1000
HOLE PATTERN MM2000
Figure 1. Mounting Dimensions Figure 2. Attaching Support Pan
Extension Brackets