Filter
Top Products
HOTEL MODE
ON Hotel Mode is ON:
The user menu is blocked.
All settings of the Hotel Mode Setup menu are in effect.
OFF Hotel Mode is OFF:
The TV operates as a normal consumer TV
LOCAL KEYBOARD LOCK
ON The television keys VOLUME +/- , PROGRAM +/- and MENU are blocked.
OFF The television keys VOLUME +/- , PROGRAM +/- and MENU function normally
REMOTE CONTROL LOCK
ON Standard Remote Control keys (System 0 & 3) are disabled.
OFF All Remote Control keys will function normally.
OSD DISPLAY
ON Normal screen information is displayed (e.g. programme information)
OFF Screen information is suppressed (except for some VGA input, if present)
SWITCH ON VOL
When the user switches the TV ON, it will play at the specified volume level.
Remark: “SWITCH ON VOL” cannot exceed the MAXIMUM VOL level. This is the volume level with which the
Hotel Mode Setup menu was entered.
MAXIMUM VOL
The TV Volume will not exceed the selected volume level.
SWITCH ON CHANNEL
When the user switches the TV ON, it will tune to the specified channel.
HIGH SECURITY MODE
ON Allows access to the Hotel Mode Setup Menu via the special BDS Setup Remote only.
OFF Allows access to the Hotel Mode Setup Menu via BDS Setup Remote or via normal Remote Control (using
special keycode sequence).
POWER ON
The Power On function allows the TV to enter a specific mode of operation (On or Standby) after the mains power
is activated.
ON When set, the TV will always turn ON after the mains power is enabled.
STANDBY When set, the TV will always turn to STANDBY after mains power is enabled
DISPLAY MESSAGE
ON Enables display of the Welcome Message for 30 seconds after the TV set is turned on
OFF Disables the display of the Welcome Message.
If OSD DISPLAY is set to OFF, then the Welcome Message is automatically disabled.
WELCOME MESSAGE
The Welcome Message function allows the TV to show a customized greeting to the hotel guest whenever the TV is
switched on. This helps to personalize the hotel experience for guests.
The Welcome Message can consist of 2 lines of text, with each line containing a maximum of 20 alphanumeric
characters. Use the arrow keys of the Remote Control to compose the Welcome Message.
To enable the display of the Welcome Message, the DISPLAY MESSAGE option must be ON