Filter
Top Products
13
Turn on
1
Press .
The display panel displays » [LOAD].
To switch to standby mode, press
again.
The standby indicator on left side »
of display panel turns red.
Find the correct viewing
channel
1
Press to turn on the unit.
2 Press DISC/USB to switch to disc mode.
3 Turn on the TV and switch to the correct
video-in channel.
Tip
The video-in channel is between the lowest
and highest channels and may be called
FRONT, A/V IN, VIDEO etc. See the TV user
manual on how to select the correct input on
the TV.
Select TV system that match
the connected TV
This DVD player is compatible with both NTSC
and PAL. For the playback of a DVD disc on this
DVD player, the color systems of the TV set and
DVD player should match.
1 Press SETUP.
2 Select [SYSTEM SETUP] >[TV SYSTEM],
and then press
.
3 3UHVVɾɼWRVHOHFWRQHRIWKHRSWLRQV
below and then press OK.
4 Get started
Caution
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from
KHDWVXQVKLQHRUÀUH1HYHUGLVFDUGEDWWHULHV
LQÀUH
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Note
Before you press any function button on the
UHPRWHFRQWUROÀUVWVHOHFWWKHFRUUHFWVRXUFH
with the remote control.
If you are not going to use the remote control
for a long time, remove the batteries.
English
EN