Filter
Top Products
20
English
Switching the system on/off
● Press STANDBY-ONB (or B on the remote
control).
➜ A countdown of 10 seconds starts for
preheating of the systme. Then, the system will
switch to the last selected source.
● Press DISC, TUNER, USB or AUX on the
remote control.
➜ The system will switch to the selected source.
To switch the system to standby mode
● Press STANDBY-ONB (or B on the remote
control).
➜ “BYE BYE” is displayed briefly. The interactive
sound settings, last selected source and tuner
presets will be retained in the player’s memory.
Power-saving automatic standby
As a power-saving feature, the system will
automatically switch to Standby mode if you do
not press any buttons within 15 minutes after a
disc has stopped playing.
Volume control
Turn VOLUME (-/+) clockwise or anticlockwise
(or press VOL +/- on the remote control) to
increase or decrease the volume level.
➜ ”VOL XX” is displayed on the display panel.
“XX” denotes the volume level.
To switch off the volume temporarily
● Press
oo
oo
o on the remote control.
➜ Playback will continue without sound and
“MUTIE” flashes.
● To activate sound reproduction, you can:
– press
oo
oo
o again;
– adjust the volume controls;
– change source.
Sound control
BASS, TREBLE and LOUDNESS sound
features cannot be activated at the same
time.
Bass enhancement
Bass adjustment enhances the bass response.
● Press BASS repeatedly to adjust the bass level.
➜ Some discs might be recorded in high
modulation, which causes a distortion at high
volume. If this occurs, switch off BASS or reduce
the volume.
Treble adjustment
The treble (high tone) setting enables you to
adjust the treble level of the system.
● Press TREBLE repeatedly adjust the treble
level.
LOUDNESS
LOUDNESS feature enables the system to
automatically increase the treble and bass sound
effect at low volume (the higher the volume, the
lower the treble and bass increase).
● Press LOUDNESS on the remote to enable or
disable LOUDNESS feature.
➜ icon appears/disappears after this feature
is enabled/disabled.
Dimming the display screen
● Press DIM on the remote control repeatedly to
select different levels of brightness for the display
screen.
Basic Operations
pg 001-020_MCD906_Eng-98 2008.9.4, 16:5520