Filter
Top Products
Quick Use and Hookup Guide
Important Notice/Warning ..................... 1
Basic TV Operation .......................... 1
Remote Battery Installation ................... 1
Remote Control Button Descriptions ............ 1
Hooking Up the TV
Basic Cable TV Connections .................. 2
Basic Cable Box Connections ................. 2
Basic Antenna TV Connections ................ 2
Using the AVI Inputs ........................ 3
Using the AV2 Inputs ........................ 3
Using the Component Video Inputs ............. 3
Using the S-Video Inputs ..................... 4
Using the Monitor (Audio/Video) Outputs ....... 4
Using the Side Audio/Video Inputs ............. 4
IMPORTANT
NOTE: This owner's manual is used with several different television
models. Notall features (and drawings) discussed inthis manual will
necessarily match thosefound with your televfflon set. This isnormal
and does not require that you contact your dealer or request service.
L_[@] The region code for this set is ALL or L
DVDs must be labeled for ALL regions orfor
Region [ in order toplay on this TV/DVD
Player.You can not play Discs that are labeled for other regions. Look
for the symbols above on your DVDs. If theseregion symbols do not
appear on your DVDs, you can notplay the DVD in thisTV_VD
Player•
yThur television has a set of controls located on the font (_f
e cabinet for use when the remote control is not needed.
3
Press the POWER button to turn the TV ON,
Press the VOL (+) button to increase the sound level or
the VOL (-) button to lower the sound level.
Pressing both buttons at the same time will display the
onscreen menu. After you are in the menu, use these buttons
to make adjustments or selections.
Press the CH - (down) or + (up) button to select TV chan-
nels. Use these buttons to make adjustments or selections in
the onscreen menu.
There is also a set of Audio and Video Input jacks located on the
side of the television cabinet, This jack panel also contains a head-
phone jack that when used will mute the TV speakers. These jacks
are great for connecting a video camcorder or any accessory device
that will only be hooked up temporarily,
puts
DVD _lYay
POWER
Remote Sensor - Sensor for activating
remote control commands when the
remote is used to control the TV.
Power Light Indicator - Light will
show while TV is powered on.
To load the supplied batteries into the remote;
Remove the battery compartment door on the back ofthe remote.
Place the batteries (2-AA) in the remote. Be sure the (+)
and (-) ends of the batteries line up correctly (the inside of
the case is marked).
Reattaeh the battery compartment door,
Installing the Remote
Control Batteries _ \_ -- -- Battery Companment Door
(shown from the bottom)
+ I
Besure to point the I (h _1 'IIA
,emoteattheRemoteI k U -Ih I +hi
Sensor windowonthe _k M__I I I / I-[J
front of the television
w en,.the omote ".,,
control to operate the I/
television. 2 "AA" Batteries _ Battel2¢ Compartment
SLEEP Button - Press the Sleep button to set the TV to automatically turn itself
off after a set period of time..
MODE (TV or VCR) Button - Press to place the remote in the TV or VCR
mode. When the desired mode is selected the green LED will light for a second
to indicate the present mode, TV or VCR.
SMILEY Button - Press to add channels in the "Quadra Surf" lists• Works with
all four colored buttons•
AUDIO Button (DVD) - Press to display the Audio menu when the DVD
player is active•
REPEAT Button (DVD) - When using the DVD player, press to repeat the
playback of a chapter, title, track or the disc•
SMART SOUND Button - Press repeatedly to choose from different factor
pre-defined sound settings• Choose from Personal (how you set the Sound Menu
options), Voice (for programming with speaking), Music (for musical program-
ming), or Theatre (for watching movies)•
MENU Button ('rv) - Press to display the onscreen menu. Also can be used
back out of the onscreen menu until it disappears from the TV s scree 1,
CURSOR Right, Left, Up or Down Buttons - Press to navigate,
adjust controls within the onscreen menu after the Menu button is pressed. These
buttons also can be used with a VCR, DVD or similar device and when in that
mode. Press the _ Left or _ Right to use as fast forward or fast reverse in
the VCR or DVD mode.
VOL(ume) + or - Buttons - Press he VOL + butto _to ncrease the TV s
sound level. Press the VOL- button to decrease the TV s sou ld level.
MUTE Button - Press 1o eliminate the sound being heard from the TV. Press
again 1o restore the TV's vdume 1o it's previous level.
OK • Button - Press the OK button to confirm selections and ar
in the on-screen menus. Also used with the Play button to stall a VCR recording
when in the VCR mode,
Pause Button (DVD) - Press m pause the playback of a DVD disc or audio
CD. Pressing repeatedly will show frame-by-frame playback of a DVD disc.
CC Button - Press m activate the Closed Captioning options. Repeatedly press
the CC button with scroll the options available on the TV screen.
®
3121 233 44461
POWER Button - Press the Power button to turn the "IV on or off.
FORMAT Button -Allows you to choose between the 4:3 04 EXPAND 4:3
screen modes.
ECT Button (DVD) -Opens/Closes the DVD disc tray and places the TV in
the DVD mode.
nels within the "Quadra Surf" lists for the four colored buttons.
Button -Allows you to delete stored channels within the "Quadra
Surf' lists for the colored buttols.
SUBTITLE Button (DVD - Press to select the subtitle language•
REPEAT A-B Button (DVD) - When using the DVD player, press to repeat
_the sequence in a title•
SMART PICTURE Button - Press repeatedly to choose from 4 different factory
pre-defined picture settings• Choose from Personal (how you set the Picture Menu
), Movies (when watching movies), Sports (for any sporting
event), or Weak Signal (used when the signal being received is not the best).
Button - When in the DVD Mode, press to toggle between DVD
• When in the TV mode, this button will have no func-
- Press to display the onscreen menu that is on the DVD
disc being played.
CH(annel) + or - Buttons - Press to select channels in ascending or descending
order.
Button - When in VCR or DVD mode, press to start the play back of a
_DVD disc or VCR tape.
STOP Button - When in VCR or DVD mode, press to stop the play back of a
_DVD disc or VCR tape.
NUMBERED (0-9) Buttons - Press the numbered buttons to select TV channels
or to enter certain values within the onscreen menu. For single channel entries,
press the numbered button for the channel you desire, the TV will pause for a sec-
\ ond or two before changing to the chosen channel.
\
A/CH Button - (Alternate Clmmlel) Press to toggle between the last view chan-
nel and the channel presently being viewed.