Filter
Top Products
Philips Limited Lifetime Warranty
The manufacturer warrants that this product shall be free from defects in material,
workmanship and assembly, under normal use, in accordance with the specifications and
warnings, for as long as you own this product. This warranty extends only to the original
purchaser of the product, and is nontransferable. Defective products, together with the
dated proof of purchase, must be returned to the place of purchase for repair or
replacement. THERE ARE NO OTHER EXPRESS WARRANTIES. Incidental and
consequential damages are disclaimed where permitted by law. This warranty gives you
specific legal rights, and you may also have other rights which vary from state to state.
Made in China. Quality Assured in USA.
Ledgewood, NJ 07852
Installation and operating instructions for UX24A Transmitter
and UX25A Receiver, both included in the RFX2001 Set.
1. Insert two AAA alkaline batteries in the UX24A transmitter, and place it in the
room where you want to use your remote control (up to 20 feet away from
where you normally sit). Make sure the front of the unit is facing you.
2. Plug the UX25A receiver’s power supply jack into the back of the UX25A and
plug the power supply into an AC wall outlet in the room where your TV, VCR,
stereo, etc., that you want to control is located
3. Plug the IR extender cable into the back of the UX25A.
4. Attach the IR emitters on the cable to the front of up to two A/V devices that
you want to control.
UX2400-02/08
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO
THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
This equipment generates and uses radio frequency energy, and if not installed and used properly, that
is, in strict accordance with the manufacturers instructions, it may cause interference to radio and
television reception. It has been type tested and found to comply with the limits for remote control
devices in accordance with the specifications in Sub-Parts B and C of Part 15 of FCC Rules, which
are designed to provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be determined by
unplugging the equipment, try to correct the interference by one or more of the following measures.
• Reorient the antenna of the radio/TV experiencing the interference.
• Relocate the equipment with respect to the radio/TV.
• Move the equipment away from the radio/TV.
• Plug the equipment into an outlet on a different electrical circuit from the radio/TV
experiencing the interference.
• If necessary, consult your local Dealer for additional suggestions.
NOTE: Modifications to this product will void the user's authority to operate this equipment.
5. Point your remote control at the UX24A Powermid Transmitter and press any
button. The Powermid Transmitter receives the Infrared (IR) signals from your
remote and converts them to Radio Frequency (RF) codes. It sends these
codes (even through walls and ceilings) to the UX25A Powermid Receiver
which converts the codes back to IR codes to control your TV, VCR, etc.
Note: The Transmitter and Receiver can be in different rooms, up to 50 feet away
from each other. You can add more Transmitters to use your remotes in more than
one room. Add more Receivers to control A/V equipment in more than one room.
Cable Box
DVD Player
IR emitter IR emitter
IR extender jack
UX25A Receiver
Trim to line