Pioneer DV-46AV TV DVD Combo User Manual


 
Additional information
08
57
En
Cannot play multi-
channel audio.
• Make sure that
Audio Output Mode
is set to
5.1 Channel
(page 46).
• Check that the Dolby Digital, DTS and MPEG Out settings (page 40)
are suitable for your amplifier/receiver—check the instruction manual
that came with your amplifier/receiver.
• DVD-Audio and SACDs do not output multichannel digital audio.
Listen through the player’s analog outputs.
• Check that the settings in the Speaker Installation screen are
correct (page 48).
• Check the audio options available from the disc menu.
Cannot listen to high-
sampling rate audio
through the digital
output.
• Make sure that
Linear PCM Out
is set to
Down Sample Off
(page 40).
• As a copy-protection measure, some DVDs do not output 96 kHz
audio. In this case, even if set to
Down Sample Off
, the player
automatically outputs the audio at 48 kHz. This is not a malfunction.
Cannot output 192 kHz or
176.4 kHz digital audio.
• The player does not output digital audio at these sampling rates. The
digital output is automatically downsampled.
Cannot output 96 kHz or
88.2 kHz digital audio.
• Check that
Linear PCM Out
is set to
Down Sample Off
(page 40).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
No DTS audio output.
• If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set
DTS Out
to
DTS
>
PCM
(page 40). If you do not do this, noise will be output when you play a
DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that the
cable is properly connected.
Audio mix does not
sound right or sounds
incomplete (for example,
inaudible dialog).
• Make sure that
Audio Output Mode
is set to
2 Channel
if you've
connected to the stereo inputs on your amplifier or TV (page 48).
Can’t hear effect of
Virtual Surround.
• Virtual Surround does not work with SACD or DVD-Audio.
• The Virtual Surround effect is only output through the
AUDIO OUT
(2ch)
analog audio outputs.
• Make sure that
Audio Output Mode
is set to
2 Channel
(page 46).
• The effectiveness of Virtual Surround varies with the disc.
Problem
Remedy
DV46AV_EN.book 57 ページ 2006年6月9日 金曜日 午後4時33分