Filter
Top Products
32
Setting Analog Audio
Connections to an AV Amplifier
or Receiver
This player is capable of both 2 channel stereo and 5.1
multichannel surround sound audio output. Use this
setting to select which analog outputs are connected to
an AV component.
Make adjustments in the [Audio Out] setting in the
Setup screen Audio 2 menu.
Settings: 2 Channel*
5.1 Channel
*Factory setting
Notes
• This setting can also be changed by using 5.1 CH MODE on
the front panel. However, this button does not work when the
GUI indicator is lit.
• When “5.1 Channel” is selected, the front right (R) and left (L)
audio channels are output from the 2 channel jacks.
• If the center or surround components are not recorded on the
disc, there will be no output from the CENTER or SURROUND
output jacks. This is not a malfunction. Speaker channels can
be verified in the Program Format indicators in the display.
• When “5.1 Channel” is selected at this setting and “Dolby
Digital 3 PCM” is selected in the [Dolby Digital Out] setting in
the Setup screen Audio 1 menu, there is no audio output from
the digital output jacks.
Turning the Digital Output On
and Off
Expert
Depending on your preferences and the type of
connections made, you may opt not to have the digital
audio signal output at all. When this setting is set to
“Off” there is no signal output from the digital audio
output jacks.
Make changes to the [Digital Out] setting in the Setup screen
Audio 1 menu in the “Expert” menu mode (page 30).
Settings: On* (Digital bitstream is output)
Off (Digital bitstream is not output)
* Factory Setting
Dolby Digital Out –
DTS Out –
Digital Out
96kHz PCM Out – 96kHz>48kHz
MPEG Ou
t – MPEG 3 PCM
Audio1
General
Language
Video
2
Move
Exit
Off
Off
On
Dolby Digital
SETUP
Audio DRC – Off
Audio Out
Speaker Setting
Virtual Surround –
Audio2 GeneralLanguageVideo1
Move
Exit
5.1 Channel
2 Channel
Off
SETUP
Setting up audio output