Filter
Top Products
The lightning flash with arrowhead
symbol, within an equilateral triangle, is
intended to alert the user to the presence
of uninsulated “dangerous voltage”
within the product’s enclosure that may
be of sufficient magnitude to constitute
a risk of electric shock to persons.
IMPORTANT
CAUTION:
TO PREVENT THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The exclamation point within an
equilateral triangle is intended to alert
the user to the presence of important
operating and maintenance (servicing)
instructions in the literature
accompanying the appliance.
H002_En
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
This product complies with the Low Voltage Directive
(73/23/EEC, amended by 93/68/EEC), EMC Directives
(89/336/EEC, amended by 92/31/EEC and 93/68/EEC).
H015A_En
CAUTION: THE STANDBY/ON BUTTON IS
SECONDARY CONNECTED AND THEREFORE DOES
NOT SEPARATE THE UNIT FROM MAINS POWER IN
STANDBY POSITION. THEREFORE INSTALL THE
UNIT SUITABLE PLACES EASY TO DISCONNECT
THE MAINS PLUG IN CASE OF THE ACCIDENT. THE
MAINS PLUG OF UNIT SHOULD BE UNPLUGGED
FROM THE WALL SOCKET WHEN LEFT UNUSED
FOR A LONG PERIOD OF TIME.
H017B_En
IMPORTANT
FOR USE IN THE
UNITED KINGDOM
The wires in this mains lead are
coloured in accordance with the fol-
lowing code :
Blue : Neutral
Brown : Live
If the plug provided is unsuitable for your
socket outlets, the plug must be cut off
and a suitable plug fitted.
Do not connect either wire to the earth
terminal of a three pin plug.
NOTE
After replacing or changing a fuse, the
fuse cover in the plug must be replaced
with a fuse cover which corresponds to
the colour of the insert in the base of the
plug or the word that is embossed on the
base of the plug, and the appliance must
not be used without a fuse cover. If lost
replacement fuse covers can be obtained
from: your dealer.
Only 5 A fuses approved by B.S.I. or
A.S.T.A to B.S. 1362 should be used.
H005B_En
The cut-off plug should be disposed of and
must not be inserted into any 13 amp socket
as this can result in electric shock. The plug
or adaptor or the distribution panel should
be provided with 5 A fuse. As the colours of
the wires in the mains lead of this appliance
may not correspond with coloured markings
identifying the terminals in your plug, pro-
ceed as follows ;
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured brown must be
connected
to the terminal which is marked with the
letter L or coloured red.
Replacement and mounting of an AC plug on the power supply cord of this unit
should be performed only by qualified service personnel.
H018A_En
CAUTION
This product contains a laser diode of higher class
than 1. To ensure continued safety, do not remove
any covers or attempt to gain access to the inside of
the product.
Refer all servicing to qualified personnel.
The following caution label appears on your unit.
Location: rear of the unit
CLASS 1
LASER PRODUCT