Filter
Top Products
9
GENERAL OPERATION
• ON/OFF
Switch on the unit by pressing POWER button (1). When system is on, press it
again to turn it off.
• FACEPLATE RELEASE
Press REL button (2) to draw out the faceplate, push the panel to draw in.
When the faceplate is drawn out, turn the faceplate upward and adjust TV display.
• SELECTING SOUND MODE
Press SEL button (6) to move display through volume, bass, treble, balance and
fader functions. Use VOLUME > (7) and VOLUME < (8) buttons to adjust the
selected mode. When mode has not been adjusted for several seconds, display
returns to previous display status (e.g. radio display or CDC display).
Volume
Adjust volume level using VOLUME > (7) and VOLUME < (8) buttons.
Bass
Press SEL button (6) for one time. Adjust bass level using VOLUME > (7) and
VOLUME < (8) buttons.
Treble
Press SEL button (6) for two times. Adjust treble level using VOLUME > (7) and
VOLUME < (8) buttons.
Balance
Press SEL button (6) for three times. Adjust sound balance between left and right
speakers using VOLUME > (7) and VOLUME < (8) buttons.
Fader
Press SEL button (6) for four times. Adjust sound balance between front and rear
speakers using VOLUME > (7) and VOLUME < (8) buttons.
• SELECTING PLAYING MODE
When the screen display is drawn in, press MODE button (12) to select desired
playing mode between radio and CDC. When the screen display is drawn out, the
unit would automatically switch into TV mode. By pressing MODE button (12), you
can select desired playing mode among TV, radio and CDC.
CAUTION: The unit cannot be switched into TV mode, when the car is running.
So at this time, you just select playing mode between radio and CDC.
• MUTE
Press MUT button (3) to cut down sound output, “MUTE” will appear on the display.
Press it again to resume the previous volume mode.
• LOUDNESS
Press LOU button (22) to increase bass output, “LOUD” will appear on the display.
Press it again to release the mode.
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)