Filter
Top Products
Mounting the Mast
26 Chapter 2
4. You can level the pole using the a carpenter’s level taking readings in two spots 90
degrees from each other on the sides as shown below. A circular bubble level is
recommended for this task though as it will tell you if the mast is plumb and level
from all angles with just a single reading. Level the pole at two different locations
that are at right angles to each other.
5. Fill the hole with quick drying cement. Stop when the cement is about two inches
from the top of the hole.
6. Let the cement completely dry before you mount the dish on
the pole.
7. Go on to the next section, “Final Installation,” to complete the installation process.
2. Use a hacksaw to cut a 45 degree angle at the bottom of the pole. This will
prevent the pole from rotating in the concrete over time.
3. Place the pole in the hole and use a small amount of dirt or stones to hold the
pole upright. You may need to attach guy wires to help keep the pole upright.
Top view of pole
Put level in 2 places at right
angles to each other
pole
Level
Not Level
45° cut
Tip
Most hardware stores should
carry an inexpensive circular
bubble level. These inexpensive
levels can tell you when the
mast is plumb and level in all
directions with just one reading.