Filter
Top Products
Using the TV’s Features
32 Chapter 3
Cable Input
16x9 Normal 1080i HDTV
English
MPAA - Not Rated 12:00 PM - 1:00 PM
12:39 PM
12:30 AM
00:30Program Title/Acquiring Channel
D
6-1 DNLJ
Digital or Analog TV Channels
A single off-air antenna can pick up both analog and digital channels. Digital channels can be
made up of primary channels and subchannels.
Note: Subchannels (sometimes called minor channels) are channels associated with the
primary channel (sometimes called the major channel). A primary channel may have just
one subchannel or multiple subchannels.
Primary
Channel
Subchannel
(if necessary)
Tip:
Use the channel banner to determine whether
a channel is digital or analog. A digital (ATSC
or QAM) channel displays a “D” before the
channel and may have a dash and second
number after it (e.g., 21-1); an analog channel
(NTSC) displays an “A” before the channel and
only has one channel number (e.g., Ch 21).
Cable Input
16x9 Normal 1080i HDTV
English
MPAA - Not Rated 12:00 PM - 1:00 PM
12:39 PM
12:30 AM
00:30Program Title/Acquiring Channel
D
6-1 DNLJ
A “D” is displayed for digital;
an “A” is displayed for analog
Direct Tuning to a Channel
1. Make sure the remote is in TV mode by pressing TV on the remote control.
2. Enter the primary channel number. This number appears in the primary channel entry box.
Press OK or wait a few seconds. If you don’t enter a subchannel, the TV tunes to the first
available analog channel or lowest digital subchannel.
3. If the primary channel number has fewer than six digits (for cable), or two digits (for
antenna) and you want to enter subchannel numbers, press the SUB CH or SUBCHANNEL
button to advance to the subchannel entry box.
4. Enter the number of the subchannel. This number appears in the subchannel entry box.
5. Press OK to tune to the channel or wait a few seconds and the TV tunes to the channel.
Note: You can always use the channel up and down buttons on the remote control to
change channels within the TV mode.
Getting a Program Description
1. Make sure the remote is in TV mode by pressing TV on the remote control.
2. Press the INFO button on the remote twice. If the information is available from the
broadcaster, a program description will appear.