Filter
Top Products
38
Programming the Remote
Programming the Remote to
Control a Laser disc player or
dvd component
The VCR2•DVD button on the remote is programmed to control
a VCR set to respond to the VCR2 button or an RCA, ProScan, or
GE laser disc player.
If you have an RCA DVD component, you can program the
VCR2•DVD button to operate it.
1. Turn on the component.
2. Look up your component and its code number in the code
list on the right.
3. Press and hold the VCR2•DVD button on the remote.
4. Enter the three-digit code from the code list.
5. Release the VCR2•DVD button, and press PWR. If the
component turns off, setup is complete.
Operate the component
After you have set up your remote, see which buttons will
operate it.
1. Point the remote at the component, and press VCR2•DVD.
If it does not turn on, press VCR2•DVD and then PWR.
2. You may want to experiment to see which buttons will
operate your component. Try pressing buttons, such as CHAN
up or down.
RCA, ProScan, and GE Codes
VCR ...................................................... 037
LaserDisc Player .................................. 037
DVD ......................................................078
This remote may not operate all
models of the brands that are shown.