Roland GR-33 Universal Remote User Manual


 
23
Chapter 2 Selecting and Playing Sounds (Patches)
Chap.
2
fig.2-06
3. While pressing [S1] on the GK-2A, step on [BANK ]
(pedal 4) or [BANK ] (pedal 3).
As long as the [S1] button is held down, pedal 4 works as
a [BANK ] (BANK UP), and pedal 3 as a [BANK ]
(BANK DOWN). The display starts to flash, and when
you step on pedal 3 or 4, numbers for the bank digit (the
middle number in the display) go down or up.
fig.2-07
4. After selecting the desired group/bank, release [S1],
then step on the pedals.
When you press a pedal, the patch will be finalized, and
the sound will change.
fig.2-08
Selecting with the Dial
If you wish to use the dial to select patches, you must make
the following setting for the dial.
1. Press [SYSTEM] to enter System mode.
2. Press [PARAMETER] to select “DIAL FUNCTION.”
fig.2-09
3. Use [VALUE] to select “PATCH&VALUE.”
PATCH&VALUE:
The dial can be used both for selecting the patch number
and for modifying values while editing.
VALUE Only:
The dial can be used only for modifying values while
editing.
4. After making the setting, press [PLAY] to return to Play
mode.
In Play mode, you can rotate the [VALUE] dial to select
all 256 patches A11–H84.
You can also use [BANK/PARAMETER] to move
forward/backward through the banks.
Using the Base Module plus an
External Foot Switch to Select Patches
By plugging a foot switch into the BANK SHIFT jack on the
rear panel, you can switch banks without pressing [S1] on the
GK-2A.
With one DP-5 (sold separately) to rise through patch bank
numbers, or with two Boss FS-5U foot switches and a branch
cable (sold separately) to move both up and down through
the patch banks, it’s possible to perform this procedure using
only your feet.
fig.2-10
While holding down S1
While holding down S1
PCS-31
BANK
UP
Red
BANK
DOWN
White