Filter
Top Products
10
Return of
pulled-out material
Material feed
Take-up of fed material
The CJ/FJ stops
operation
Take-up of
fed material
MOTOR ERROR
TURN OFF POWER
6. Operating Conditions for the TU
The TU takes up material fed from the CJ/FJ. Performing an operation to pull out material from the CJ/FJ generates corresponding force,
and so the CJ/FJ displays the error message, and operation stops. When performing printing in particular, such a stop in operation may
affect the printing extremely, such as misalignment of the printing location.
*Material can not be taken up with TU when CJ performs cutting. TU can be used only when printing.
OK NO GOOD
CJ/FJCJ/FJ
TUTU
When using the TU, make the settings for the following conditions.
For Both the CJ and the FJ
• At the display menu, set [AUTO SHEET CUT] to [DISABLE].
• Do not use the [SHEET CUT] key to separate the material.
• Do not use the
or keys to return the material.
For the CJ Only
• Turn off the cutting function on the program you're using.
• From the display menu, set [PREFEED] to [DISABLE].
• From the display menu, select something other than [ROLL] for the material.
• Do not perform automatic detection of the base point or align point when loading
material.
• When loading material, use the right-hand grit roller (to ensure that the material overhangs the TU sensor area).
For the FJ Only
• Load the material so that it is close to the right-hand side (to ensure that the material overhangs the TU sensor area).