Roland TU-500 Universal Remote User Manual


 
14
8. Starting Operation
Do not allow the hands or hair to
touch the paper tube, flange, or
sheet during take-up.
The hands or hair may become caught.
During operation, do not enter the sensor's detection area. Doing so will result in excessive take-up and cause
printing to be interrupted.
When in the manual mode, make sure there is some slack in the material before attempting to perform take-up.
NOTICE
Turn on the power.
1
Data is sent from the computer and
printing on the CJ/FJ starts.
3
2
Set the desired direction of take-up.
Forward
Take-up
Backward
Take-up
Pull out the material and ensure a certain amount of slack,
as shown in the figure. Move the sheet loading lever to
secure the material in place.
3
Move the [MANUAL] switch to the [BACKWARD]
setting and take up one turn's worth of material.
After take-up, maintain slack as shown in the figure to
keep the material from being drawn taut by take-up.
4
Front <---