Samsung 20070529160005000 DVD Recorder User Manual


 
Connecting &
Setting Up
18 - English
Step 2 : Connecting HDMI/DVI to a TV
If your TV has a HDMI/DVI input, connect the HDMI/DVI cable to the TV. You will enjoy the best quality image and
sound.
Connecting to a TV with an HDMI Jack
Using an HDMI-HDMI cable (not included), connect the HDMI OUT jack on the rear of the DVD Recorder to the HDMI
IN jack of your TV. Press the input selector on your TV remote control until the HDMI signal from the DVD Recorder
appears on your TV screen.
HDMI OUT
Caution
To watch through the HDMI output, set the digital audio
output to PCM. (See page 34-35)
Depending on the HDMI device(TV/HDMI Receiver) you use,
audio may not be supported. If your TV does not support
Dolby digital/DTS, Audio output is not available when you set
the Digital output to Bitstream or select DTS On in the Audio
setup menu. In this case, set the digital audio output to PCM
or DTS Off.
If you use an HDMI cable to connect a Samsung TV to the
DVD recorder, you can operate the recorder using the TV
remote control. (This is only available with SAMSUNG TVs
that support Anynet + (HDMI-CEC). ) (See pages 31)
Please check the logo (If you TV has an
logo,then it supports Anynet+ function.)
The DVD-R160 supports 1080p resolution. This is only
available when an HDMI cable is connected to a TV that
supports 1080p resolution.