Filter
Top Products
• When you press the Anynet+ button on the TV’s
remote control, the OSD below will appear.
- Select device: Use this option to select device.
- Record: Use this option to record.
- Device Operation : Same as ANYKEY button ( )
on the DVD Recorder remote control.
- Menu on Device: Same as MENU button ( ) on the
DVD Recorder remote control.
32 - English
System Setup
■
By pressing the PLAY button of the recorder
while watching TV, the TV screen will change
to the play screen.
■
If you play a DVD when the TV power is off,
the TV will power on.
■
If you turn the TV off, the DVD Recorder will
power off automatically. (When the DVD
Recorder is recording, it can’t be power off.)
■
If you change the HDMI to other sources
(Composite,Component,RF...etc)on yourTV
while playing a DVD disc,theDVD Recorder
will stop playing.The DVD Recorder may
keep playing certain discs based on their
content.
NOTE
■
The Menus are slightly different depending on whether a
disc is inserted or not .The menus described on the
next few pages are with no disc in the unit.
■
The menus are not available during playback or recording.
NOTE
Clock Set
This menu is used to set the current time. You must set
the time first to use timer recording.
1
With the unit in Stop mode/No Disc mode, press the
MENU button.
2
Select Clock Set using the …† buttons, then press
the ENTER or √button.
Clock Set menu will be displayed.
3
Select Auto Clock Set using the …† buttons, then
press the ENTER or √ button.
4
Select the sub menu(Clock Data CH, Time Zone
or Daylight Saving) using the
…†
buttons, then
press the ENTER or √ button.
Clock Data CH
Select a channel that carries a time signal using the
…†
buttons then press the ENTER button.
•
Select Auto to set the clock data channel automatically.
Auto Clock Set
Clock Set
DVD-Recorder
No Disc
Timer Rec.
Setup
Auto Clock Set
√√
Manual Clock Set
√√
RETURNENTERMOVE EXIT
Auto Clock Set
DVD-Recorder
No Disc
Timer Rec.
Setup
Clock Data CH : Automatic
√√
Time Zone : Automatic
√√
Daylight Saving : Automatic
√√
RETURNENTERMOVE EXIT