Filter
Top Products
English - 26
Checking the Digital-Signal Information
You can get information about the signal status.
1. Press the
MENU button to display the menu.
Press the ▲ or ▼ button to select “Channel”, then press the ENTER
button.
2. Press the ▲ or ▼ button to select “Signal Information”, then press the
ENTER
button.
3. Press the
EXIT button to exit.
If the signal status is poor, the “No signal.” message is displayed.
While viewing a Digital channel, this function can be selected.
➣
➣
LNA(LowNoiseAmplier)
If the TV is operating in a weak-signal area, the LNA function can improve the reception (a low-noise preamplier boosts the
incoming signal).
1. Press the
MENU button to display the menu.
Press the ▲ or ▼ button to select “Channel”, then press the ENTER
button.
2. Press the ▲ or ▼ button to select “LNA”, then press the ENTER
button.
3. Press the ▲ or ▼ button to select “Of
f” or “On”. Press the ENTER button.
4. Press the
EXIT button to exit.
While viewing an Analogue channel, this function can be selected.
➣
Channel
Channel Mode : Added Ch.
Fine Tune
Signal Information ►
LNA : Off
Signal Information
Frequency : 482000 KHz
Service ID : 0401
Multiplex : (TSID 0004, ONID 20fa)
Network : (ID 20fa)
Bit error level
0
Signal Strength
88
ReturnEnter
OK
Channel
Fine Tune
Signal Information
LNA : On ►
Off
On
Channel
Fine Tune
Signal Information
LNA : Off ►
BN68-01409L-00Eng.indb 26 2008-08-14 �� 8:39:46