Filter
Top Products
19
User’s Guide
18
4) Manipulating the MATRIX SWITCHER
!!
MANUAL SELECT action
This is a function for putting out camera visuals of your discretion in
the monitor of your discretion.
Monitor selection is MON+NO.+ENTER, and camera selection is
CAM+NO.+ENTER. At this time, install so that the matrix switcher
input channel number and the address no of either the camera or the
receiver unit are the same.
The selected monitor number and the camera number get indicated in
the first line of the LCD.
And, the matrix switcher's action mode gets indicated in the second line.
@@
SEQUENCE SWITCHING action
This is a function for automatically converting the cameras
corresponded to each monitor of the matrix switcher.
When you press the SEQUENCE button in the manual select mode,
cameras corresponded with monitors indicated in the LCD get
consecutively converted.
At this time, sequence run is indicated in the LCD. If you press the
HOLD button in the sequence run mode, automatic conversion actions
are stopped, and sequence hold gets indicated in the LCD.
If you press the NEXT or BEFORE button in this state, it gets
converted to the next visuals or the previous visuals of the visuals being
put out presently.
If you want to automatically convert again, press the SEQUENCE
button. If you want to convert the SEQUENCE RUN Mode to the
manual select mode, press CAM+NO.+ENTER.
3) Manipulating the RECEIVER UNIT
!
For receiver unit manipulation, as only those applying to the cam no.
indicated in the LCD are possible, first select the camera you wan to
manipulate. For camera selection, when you press CAM + NO. +
ENTER, the concerned camera number gets indicated in the LCD.
(The camera number is the address number of the receiver unit)
@
In the
third
line of the LCD, the camera's action state gets indicated.
Initially, it appears as “MANUAL”. And, in this state, by using the Joy
Stick and Lens control buttons, you can manipulate the light turning
mark and the lens.
#
PRESET action
This is a function for selecting and watching the preset POSITION set
up in the receiver unit. If you want to select the preset position you
want, press the PRESET button, put in the appropriate number in the
position you want, and press the ENTER button. At this time, the LED
of the PRESET button gets turned on, “PRESET [ ]” gets indicated in
the LCD. If you want to cancel the preset, press the PRESET button
once again.
$
AUX power control
This is a function for manipulating the aux power of the receiver unit.
If you want to put out the power of AUX1~AUX4, press the appropriate
AUX button. At this time, in the fourth line of the LCD, the appropriate
aux gets indicated. If you want to cancel the aux power output, press
the appropriate AUX button.
SSC-1000 (gb) 2009.1.8 1:38 PM Page 18