Filter
Top Products
《7》
Names and Functions of Each Part
(1) Camera Setup Section
① RESET : Resets camera power.
② PRESET : Moves camera to the preset location (see p.16).
③ LIGHT : Toggles the lights around the camera on and off.
④ AUX : Toggles the camera’s external case AUX on and off.
⑤ TOUR :
Sets more than 1 group for tour and performs continuous group action (see p.19).
⑥ SALVO : Not used; will be applied to F/W in the future.
⑦ SWING : Continuously travels between two assigned locations horizontally (pan) or
vertically (tilt) (see p.17).
⑧ GROUP : Repeats sequential surveillance of assigned preset locations with preset
movement rates and intervals (see p.18).
⑨ AF : Sets the focus to automatic or manual after operating the camera (see p.23).
⑩ OSD : Displays the camera OSD menu (see p. 24).
⑪ FUNCTION : Used to perform 2 functions or more at the same time (see p.8).
※ Some buttons in the camera setup section may not be supported or may be used differently depending on the
camera manufacturer. Please refer to the table below for the buttons supported by the major camera manufacturers.
SPD-1600 SPD-2200 SPD-2500
PELCO-D
PANASONIC
(WV-CS854A)
SAMSUNG ELECTRONICS
(SCC-643/641)
Not used; will be applied to F/W in the future.
O(AUTO-PAN)
RESET O O O O O X
PRESET O O O O O O
TOUR O O O X X X
SALVO
SWING O O O X
GROUP O O O X O (AUTO-SEQ) O (SCAN)
AF O O O O O O
OSD O O O O O O
LIGHT Applies only to systems with housing and receivers that support the light function. (SRX-100B only)
AUX Applies only to systems with AUX terminals. (SRX-100B only)