Filter
Top Products
INSTALLATION
English - 11
Chapter Two
INSTALLATION
e
e-
Connecting VHF and UHF Antennas
If your antenna has a set of leads that
look like this, see “Antennas with
300-ohm Flat Twin Leads” below.
If your antenna has one lead that looks
like this, see “Antennas with 75-ohm
Round Leads” on the next page.
If you have two antennas, see “Separate
VHF and UHF Antennas” on the next page.
Antennas with 300-ohm Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has
300-ohm twin flat leads, follow the directions below.
1
Place the wires from the
twin leads under the
screws on the 300-75 ohm
adaptor (not supplied).
Use a screwdriver to
tighten the screws.
2
Plug the adaptor into the
“ANT IN” terminal on the
rear panel.
AA68-03644A-00Eng 6/23/05 2:33 PM Page 11