Filter
Top Products
10
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
ANALOG AV CONNECTIONS
USING THE BACK VIDEO AND AUDIO
INPUT JACKS TO CONNECT A VCR
(OR OTHER ANALOG DEVICE)
Switch off DTV and external equipment before connect-
ing cables.
(Cables are not supplied.)
BACK VIEW
OF VCR
DTV VIDEO2
AV INPUT
JACKS
1
Connect VCR’s Audio Video Out to the DTV’s
VIDEO2 Video In jacks.
NOTE: For Mono VCR (Single Audio Jack), connect VCR
Audio Out to DTV Audio (L) Input.
22
Optional
Connect VCR’s S-Video Out to the DTV’s S-Video In
Jack.
NOTE: S-Video jack connection overrides Video jack con-
nection (VIDEO2).
3
Press POWER to turn on the DTV, then turn on exter-
nal equipment.
4
Press INPUT to select
Video2
to
view the VCR program.
What you will need for connections:
Audio Video Cable – 1
S-Video Cable – 1
S-VIDEO
JACK
22
1
REMOTE CONTROL
4
3
2
■
“No Signal” will appear randomly on the screen when no signal is
detected at the VIDEO2 input jack.
■
Press the INPUT key after connecting cables to access the AV
inputs. There is NO need to tune to a blank channel.
■ Position your DTV at least 2 feet from stereo speakers. The magnets
in the speakers may affect the picture quality.
CONNECTING ANALOG AUDIO OUT
JACKS TO A STEREO AMPLIFIER
Switch off DTV and external equipment before connecting
cables.
(Cables are not supplied.)
STEREO AMPLIFIER
BACK VIEW
OF DTV
1
Connect the DTV Audio Out (L/R) to the Stereo
Amplifier In (L/R).
2
Press POWER to turn on the DTV, then turn on
external equipment.
NOTE: Do not connect external speakers directly to the DTV.
1
REMOTE CONTROL
2
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must run All
Channel Search twice before you can select the AV inputs.