Sanyo HT27546 CRT Television User Manual


 
22
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
Problem Check these Conditions Try these Solutions Page No.
Cannot select or
scan some
channels.
Channel may be removed from
memory.
Check antenna connections.
No digital signal being broadcast.
Signals are weak.
V-Guide is set to block programming.
Select CH. Scan Memory and manually
add channels or start CH. (channel)
search.
Turn Antenna or install signal booster.
Set V-Guide to “Allow All” or press the
RESET key to clear all settings and
restart channel search.
17
18 ~ 19
13
Remote Control
will not work TV.
Check batteries.
Check to see if TV is plugged in.
Replace batteries, two “AAA.”
Aim remote control at front of TV.
6,12 ~ 13
Cabinet makes
popping sound.
This is a normal condition during
warm-up and cool down of the plastic
cabinet parts.
Because of the Quality we build into our product,
very few problems are actual DTV defects. Most prob-
lems only involve simple hookup or setup changes that
can be solved by the customer. Please check the chart
below and try the solutions listed for your problem. If the
problem still persists, before returning your DTV, please
visit our website at www.sanyoctv.com or call us toll
free at 1.800.877.5032.
We can Help!
HELPFUL HINTS (Problems/Solutions) Continued
CARE AND CLEANING
CLEANING THE CABINET
The surface of the cabinet can be damaged if not properly maintained. Many common
household aerosol sprays, cleaning agents, solvents, and polishes will cause permanent
damage to the fine surface.
1. Unplug the power cord before cleaning the television.
2
..
Clean the cabinet with a soft dry cloth.
NOTE: Never spray liquids on the screen because they can run down and drip onto
the chassis. This may cause component failure not covered under Warranty.