Sanyo HT27546 CRT Television User Manual


 
6
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
NOTES:
Channel information found during the All Channel Search is
stored in the Channel Scan Memory database. After the All
Channel Search is completed, the DTV will tune to the lowest
Digital channel or lowest Analog channel if no digital channels
are found.
If the DTV does not detect any
digital or analog channels, a
message advising the viewer
to check the cables and
antenna connections will
appear. In this case, you must
press the
CHANNEL UP
(
CH )
key again to repeat the
channel search process. If
after two searches the DTV still fails to detect any channels,
the DTV will tune to analog channel 3. These two channel
searches are necessary even if you plan to use the DTV
only as a monitor.
If no analog or digital channels are found after the second
search, All Channel Search will default to off-air analog chan-
nels 2 through 69 and digital channel D3-1. Select analog
channels using the remote control keypad. See page 12, item
number 2.
4
ANA (Analog) ANTENNA SIGNAL
(Optional)
To change the initial ANALOG tuning system setup
(from antenna to cable or cable to antenna, use the
on-screen menu. See “Ana (Analog) Antenna
Signal” on page 16.
2
INSTALL TWO “AAA” BATTERIES
IMPORTANT NOTE: Spent or discharged batteries must be recycled
or disposed properly in compliance with all applicable laws. For
detailed information, contact your local County Solid Waste
Authority.
Install two “AAA” Batteries (not
included) so that the “+” and
“–” marks on the batteries
match the “+” and “–”
marks inside the Remote.
To review the Remote
functions, go to
pages 12 ~ 13.
NOTE: Use two “AAA”
Alkaline batteries.
Remove the batteries if the remote control will not be used for a
month or more. Weak batteries may leak and cause damage.
(Normal battery life is roughly six months.)
If batteries have leaked in the Remote Control Unit, carefully wipe
the case clean and load new batteries.
3
ALL CHANNEL SEARCH
When the television is powered on for the first
time, it automatically checks for the presence of an
RF signal.
Press the POWER key to
turn on the DTV.
Then press the CHANNEL
UP (CH ) key to automat-
ically search for available
channels: Digital (ATSC)
and Analog (NTSC).
The All Channel Search con-
tains two processes that are
executed simultaneously for
digital and analog channels.
The Search will take a few
minutes to complete.