Filter
Top Products
© 2004 Scientific-Atlanta, Inc. All rights reserved.
AllTouch, Explorer, Scientific-Atlanta and the Scientific-Atlanta
logo are registered trademarks and AT8400 is a trademark of
Scientific-Atlanta. Inc. Other trademarks mentioned are property
of their respective owners. Product and service availability subject
to change without notice.
Scientific-Atlanta, Inc., 5030 Sugarloaf Parkway, Box 465447,
Lawrenceville, GA 30042
www.scientificatlanta.com
February 2004. Printed in USA 4006382 Rev A
FCC Compliance
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
Note
This equipment has been tested and found to
comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communication. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and the receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Any changes or modifications not expressly
approved by Scientific-Atlanta could void the
user’s authority to operate this equipment.
About Cable Codes
Your cable service provider may have
“locked” a valid cable code into your
remote to keep you from changing the
cable code unintentionally.
If you need to program the remote to
operate a different device, use the
following steps to unlock the remote.
1. Press and hold the SELECT key and
the CBL key until the LED blinks
twice.
2. Press 9-9-6.
Note:As you press each digit, the
mode key should blink.
3. Press CH
▼ to unlock the remote.
Result: You can now set up your CBL
key with a different cable code using
the set-up mode key.
Enter all 4 digits to program the
CBL mode key.
Cable Codes
Brand Code
ABC 0004
Contec 0008
G.I. 0011, 0012
Gold Star 0010
Jerrold 0007, 0011, 0012,0015
Memorex 0006
Motorola 0011, 0012
Panasonic 0006, 0009
Pace 0000, 0001 , 0002, 0003
Paragon 0006
Pioneer 0010, 0014
Pulsar 0006
Quasar 0006
Runco 0006
Scientific-Atlanta 0000, 0001, 0002, 0003,
0004, 0005, 0016
Samsung 0010
Starcom 0011
Tocom 0007
Toshiba 0006
Zenith 0006, 0013
Satellite Codes
Brand Code
Echostar 0021
Hughes 0017, 0020
Mitsubishi 0020
RCA 0018
Sony 0019
CBL Setup Codes AUX Setup Codes
AT8400
™
AllTouch
®
Remote Control Rev B
User’s Guide
7