Sharp LC 42D43U Flat Panel Television User Manual


 
QUICK REFERENCE
Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
Before performingwork spread cushioning over tile base area to laythe TVon. Thb will prevent it from being damaged.
Attach the stand inthe correct direction.
Besure to follow the instructions,incorrect installation of the stand may result inthe "IVfailing over.
[] LC-46D43U/LC-52D43U
Confirm that there are 10 screws (6 short
screws and 4 long screws) supplied with the TV,
1
"'" TTTT
Attach the two supporting posts for the stand
unit onto the base using the box for the stand
unit as shown below.
(Close<_pof the upper sideofthe standunit)
eYSt_ortscrew f"
Insert each of the protrusions on the two
supporting posts into the openings on the
upper side of the base.
Insert and tighten the 6 short screws with
the hex key (supplied with the product) in the
order of (_, (_ and (_.
[] LC-42D43U
Confirm that there are 8 screws (4 short screws
and 4 long screws) supplied with the TV.
Set the post for the stand unit onto the box.
Attach the base to the post.
Insert and tighten the 4 short screws into
the 4 holes on the bottom of the base,
Hex key_(_) (_='
Short screw
1_ Insert the stand into the openings on the
bottom of the TV.
(_) Insert and tighten the 4 long screws into
the 4 holes on the rear of the TV.
To detach the stand, pertorm the steps in reverse order.
(_ Insert the stand into the openings on the
bottom of the TV.
(_) Insert and tighten the 4 long screws into
the 4 holes on the rear of the TV.
Hex key_(_) (_T""
Longserew
oftoush,on TI
To detach the stand, pertorm the steps in reverse order.
Q-7