Filter
Top Products
31
KDL-V32/40A12U
2-629-164-14(1)
Using the Menu
Option Description
Programme Presets programme channels manually.
1 Press M/m to select “Programme”, then press OK.
2 Press M/m to select the programme number you want
to manually tune (if tuning a VCR, select channel 0),
then press <.
3 Press M/m to select “Channel”, then press OK.
4 Press ,.
5 Tune the channels as follows:
If you do not know the channel number (frequency)
Press M/m to search for the next available channel. When a
channel has been found, the search will stop. To continue
searching, press M/m.
If you know the channel number (frequency)
Press the number buttons to enter the channel number of the
broadcast you want or your VCR channel number.
6 Press OK.
7 Press m to select “Confirm”, then press OK.
8 Press m to select “OK”, then press OK.
Repeat the procedure above to preset other channels manually.
Channel
Label Assigns a name of your choice, up to five letters or numbers, to the
selected channel. This name will be displayed briefly on the screen
when the channel is selected.
1 Follow steps 3 to 5 of “Programme Labels” (page 30).
2 Press m to select “Confirm”, then press OK.
3 Press m to select “OK”, then press OK.
AFT Fine-tunes the selected programme number manually if you feel
that a slight tuning adjustment will improve the picture quality.
(Normally, fine tuning is performed automatically.)
1 Press M/m to adjust the fine tuning over a range of -15
to +15, then press OK.
2 Press m to select “Confirm”, then press OK.
3 Press m to select “OK”, then press OK.
To restore automatic fine tuning, select “On” in step 1.
Audio Filter Improves the sound for individual channels in the case of distortion
in mono broadcasts. Sometimes a non-standard broadcast signal
can cause sound distortion or intermittent sound muting when
watching mono programmes.
1 Press M/m to select “Low” or “High”, then press OK.
If you do not experience any sound distortion, we recommend
that you leave this option set to the factory setting “Off”.
2 Press m to select “Confirm”, then press OK.
3 Press m to select “OK”, then press OK.
Note
You cannot receive stereo or dual sound when “Low” or “High” is
selected.
Continued
01GB-KLV40XUK.book Page 31 Wednesday, August 31, 2005 4:42 PM