Sony DSR-70 DVD Recorder User Manual


 
Chapter 5 Special Editing and Recording/Playback
80 Chapter 5 Special Editing and Recording/Playback
When you combine two DSR-70/70P units, you can
perform sequential recording from one unit to another.
(In the following explanation of two-unit sequential
recording, the controlling unit is referred to as the
recorder and the controlled unit as the player.)
For overwriting recording using only two cassettes, the
last 6 hours of recording is always available.
By replacing the cassette approximately every 3 hours,
indefinite continuous recording is possible.
Sequential recording using two DSR-70/70P units can
be performed in the following two ways.
Inputting external video and audio signals to both the
player and recorder.
Inputting external video and audio signals to the
player and inputting the video and audio signals
output from the player to the recorder.
Recording
Sequential Recording Using Two Units
1 Insert the cassettes into the recorder and player.
2 Press the recorder side RECORDER button to light
the RECORDER indicator on the recorder.
3 Simultaneously press the recorder side ENTRY/
SHIFT button, REC/SEQ button, and PLAY
button.
The recorder side begins recording.
The STANDBY indicator of the player goes out.
The POWER indicator turns to orange.
The player starts recording automatically when the
remaining time of the recorder side tape reaches 2
minutes.
The setting of setup menu item 014 affects what
happens when a tape ends.
When AUTOMATIC OVERWRITE is selected
Endless recording on the same cassette continues,
overwriting on the previous contents.
When MANUAL CASSETTE REPLACE is
selected
When the tape end is reached, the tape is rewound
and the EJECT button begins to flash.
To continue recording, insert a new cassette into
the recorder. The recorder will start recording
automatically when the remaining time of the
player side tape reaches 2 minutes.
In either case, you can use the same operating
procedure, but there are some differences in
equipment/signal connections and basic settings
between the two cases.
For more information about equipment/signal connections
and basic settings for two-unit sequential recording, see the
section “Connections for Sequential Recording Using Two
Units” on page 118.
Use the following procedure. You can do control panel
operations on the recorder during sequential recording.
Rewind the tape to the beginnig beforehand.
2
3
OFF
ON
ON
OFF
LOCAL
REC INHI
REMOTE
INT
EXT
MENU
TC CHARACTER
SET
AUDIO IN
VIDEO
CH1,1/2 CH2,3/4
AUDIO
TRIM
LIST MARK
CLIP
LINK
ENTRY SHIFT
IN OUT
ASSEMBLE INSERT
TC
–+
DELETE
EJECT REW PLAY F FWD
SERVO
CH-1/2
CH-3/4
PREROLL
REC SEQ EDIT
METER
REC
INHI
REVERSE
PLAYER
RECORDER
FORWARD
SHUTTLE JOG
)
0
r
p
6
4
STOP
STANDBY