Sony DSR-70 DVD Recorder User Manual


 
Chapter 5 Special Editing and Recording/Playback
Chapter 5 Special Editing and Recording/Playback 85
Digitally Dubbing Signals in DVCAM Format
(Optional DSBK-140 or DSBK-150 Required)
In addition to straightforward tape dubbing, you can
also use this unit to digitally dub signals in DVCAM
format automatically from the beginning of the tape to
the end, through an i.LINK or SDTI(QSDI) interface.
When a tape recorded on a DSR-1/1P Digital
Videocassette Recorder or DSR-130/130P Digital
Camcorder is dubbed, the ClipLink log data held in the
cassette memory is also copied.
To use an i.LINK interface requires the optional
DSBK-140 board, and to use an SDTI(QSDI) interface
requires the optional DSBK-150.
For information about connections and basic settings, see
the section “Connections for Digitally Dubbing Signals in
DVCAM Format” on page 124.
Notes
Use a tape which is recorded in the DVCAM format.
A tape recorded in DV format cannot be used as a
source tape for dubbing through an SDTI(QSDI) or
i.LINK interface.
Regardless of the audio recording mode setting of
this unit, dubbing is performed with the original
audio recording mode unchanged (two-channel mode
(48 kHz) or four-channel mode (32 kHz)).
Approximately the last 2 minutes of the tape may not
be copied because of differences in tape lengths. (If
an Index Picture is recorded in this portion, it may
also not be copied.)
A continuous recorded section of approximately 5
seconds is required before the recording start point. It
is recommended to record beforehand color bars or a
similar signal at the start point of the source tape to
be dubbed on this unit.
Perform the following procedure.
1 On the recorder, hold down the ENTRY/SHIFT
button and press the MENU button.
The SYSTEM MENU screen appears on the LCD
monitor.
SYSTEM MENU screen displayed when using
the i.LINK interface (DSBK-140)
1,7
3
2,5
1
OFF
ON
ON
OFF
LOCAL
REC INHI
REMOTE
INT
EXT
MENU
TC CHARACTER
SET
AUDIO IN
VIDEO
CH1,1/2 CH2,3/4
AUDIO
TRIM
LIST MARK
CLIP
LINK
ENTRY SHIFT
IN OUT
ASSEMBLE INSERT
TC
–+
DELETE
SYSTEM MENU
i.LINK DUBBING
(Continued)