Sony DSR-70P DVD Recorder User Manual


 
Chapter 8 Connections and Settings
124 Chapter 8 Connections and Settings
Connections for Digitally Dubbing Signals in
DVCAM Format (Optional DSBK-140 or DSBK-150
Required)
You can use this unit to digitally dub signals in
DVCAM format automatically from the beginning of
the tape to the end, through an i.LINK or SDTI(QSDI)
interface.
For information about how to carry out digital dubbing, see
the section “Digitally Dubbing Signals in DVCAM Format”
on page 85.
Connecting two DSR-70/70P units using the
i.LINK interface (DSBK-140 i.LINK/DV Input/
Output Board)
Make the same connections and settings as described
in the section “Connections for Cut Editing Using Two
DSR-70/70P Units” on page 36.
Connecting two DSR-70/70P units using the SDTI(QSDI) interface (DSBK-150 SDTI (QSDI) Input/
Output Board)
Player settings
Switch Setting
REMOTE/LOCAL switch REMOTE
Recorder settings
Switch Setting
REMOTE/LOCAL switch LOCAL
When connecting this unit with a DSR-60/60P/
80/80P/85/85P unit using the SDTI(QSDI)
interface (DSBK-150)
Replace the DSR-70/70P (player) shown in the above
diagram with a DSR-60/60P/80/80P/85/85P unit and
make the same connections as shown above.
The SDTI(QSDI) interface connector of the DSR-60/
60P/80/80P/85/85P is marked “QSDI(OUTPUT)”.
REMOTEREMOTE
SDTI
(QSDI)
OUT
SDTI
(QSDI)
IN
DSR-70/70P (player)
DSR-70/70P (recorder)
2
1
1 75 coaxial cable (not supplied)
2 RCC-5G/10G/30G 9-pin remote control
cable (length 5 m (16 ft)/10 m (33 ft)/30 m
(98 ft), not supplied)