Sony DSR-70P DVD Recorder User Manual


 
Chapter 1 Overview
Chapter 1 Overview 23
3 SET UP/BLACK LEVEL knob
Adjusts the setup level (for DSR-70) or the black level
(for DSR-70P). This knob is a push switch. When you
press it to bring it into the raised position, the setting
becomes VARIABLE. When you press it again to
depress it, the setting returns to PRESET.
PRESET: This is the normal setting. Regardless of
the knob position, the setup level (for DSR-70) or
the black level (for DSR-70P) is set to the
standard value.
VARIABLE: The setup level can be adjusted across
a range of ±30 IRE (for DSR-70) and the black
level can be adjusted across a range of ±210 mV
(for DSR-70P).
4 CHROMA PHASE knob
Adjusts the chroma phase (phase relative to burst).
This knob is a push switch. When you press it to bring
it into the raised position, the setting becomes
VARIABLE. When you press it again to depress it, the
setting returns to PRESET.
PRESET: This is the normal setting. Regardless of
the knob position, the chroma phase is set to the
standard value.
VARIABLE: The chroma phase can be adjusted
across a range of ±30˚.
5 POWER indicator
Lights green when the POWER switch 8 is turned on,
and changes to red when recording starts.
6 LEVEL (speaker/headphones level) knob
Adjusts the volume of the speaker or headphones
connected to the HEADPHONES jack 7.
7 HEADPHONES jack (stereo phone jack)
Connect headphones. The speaker is muted when
headphones are connected.
8 POWER switch
Powers the unit on and off. When the unit is powered,
the POWER indicator 5 lights.
Top Panel
1 Battery connector
2 BREAKER button
3 Shoulder belt attachment
fixture
Slide the cover off while pressing the lever.
1 Battery connector
Connect a BP-L60/L60A//L90/L90A Battery Pack,
DC-L90 Battery Adaptor, or AC-DN2/DN2A AC
Adaptor.
When the AC-550/550CE AC Adaptor or another
power supply has been connected to the DC IN
connector on the rear panel, the power from the DC IN
connector is used instead of the power from this
connector.
For more information, see “Power Preparations” on page
29.
Note
The AC-DN1 AC Adaptor and the BP-L40 and NP-1B
Battery Packs cannot be used.