Filter
Top Products
41
Playback
7
Press the j button to select “A POINT.”
8
Press the K (IN) button.
The display changes as follows.
9
Press the j button to select “A PRESET.”
10
Press the k (OUT) button.
The A PRESET MODE screen appears. The time
code value of the current point A is displayed below
the screen title.
11
Use the K (IN) or k (OUT) button to select the
digit in the time code value display that you want to
change.
Each press of the button causes the digit to the left or
right to begin flashing. Holding the button down
moves the flashing digit continuously.
If you want to clear the time code value, press the
RESET button. The value is cleared to 00:00:00:00,
and the leftmost digit begins flashing.
12
Press the J (CUE) or j button to increment or
decrement the value of the flashing digit.
Each press of the button increments or decrements the
value. Holding the button down increments or
decrements the value continuously. To change other
digits, return to step 11.
13
Press the SET button to confirm the defined value.
The message “NOW SAVING...” is displayed on the
monitor screen and “Saving...” is shown in the time
counter display while the new setting is being saved in
memory.
Note
The new setting may be lost if you power off the unit
during the saving operation. Wait until the saving
operation is completed before powering the unit off.
If you want to discard the changed value
Press the MENU button instead of pressing the SET
button to return to the menu display, then press the
MENU button again to end the menu operation
without saving the changed value into memory.
After the saving operation is completed, the monitor
screen and time counter display return to the REPEAT
FUNCTION setting display as shown in step 9.
>>> Disk top
SETUP MENU
OPERATIONAL FUNCTION
REPEAT FUNCTION
REPEAT TOP
* VIDEO TOP
A POINT
:
V.TOP
:
V.END
Monitor screen
Time counter display
>>> A point
SETUP MENU
:
V.TOP
:
V.END
OPERATIONAL FUNCTION
REPEAT FUNCTION
REPEAT TOP
* VIDEO TOP
A POINT
Monitor screen
Time counter display
>> REP TOP
SETUP MENU
OPERATIONAL FUNCTION
REPEAT FUNCTION
REPEAT MODE
REPEAT TOP
REPEAT END
A PRESET
B PRESET
:OFF
.
A
:
V.END
Monitor screen
Time counter display
>> A preset
SETUP MENU
OPERATIONAL FUNCTION
REPEAT FUNCTION
REPEAT MODE
REPEAT TOP
REPEAT END
A PRESET
B PRESET
:OFF
.
A
:
V.END
Monitor screen
Time counter display
A PRESET MODE
A 00:00:00:00
INC/DEC : ( )( )KEY
SHIFT : ( )( )KEY
CLEAR : RESET KEY
DATA SAVE : SET KEY
TO MENU : MENU KEY
Monitor screen