Filter
Top Products
57
Receiving Data
2
If the destination host is correct, press the SET button.
To select the destination host, execute steps 2 to 4 of
“Sending Clip Data” (page 55) and press the SET
button.
Preparations for communications start.
When the preparations finish, the message “Issuing
transfer request. Will begin transfer after the end of
transfer standby.” appears.
Up to 29 transfer requests can be placed on standby.
When the 30th request is issued, the message
“Request queue full. Cannot send clip.” appears and
the transfer is rejected.
To cancel the transfer
In step 2, press the MENU button instead of the SET
button.
Receiving Data
You can specify the names of clips recorded by other
recorders on the network and receive those clips over the
network. After receiving the data, you can choose whether
to save or delete it. Up to 100 data items can be received.
The following procedure allows you to receive clip data
that has been recorded on other recorders.
Note
Data cannot be received when there is 10 minutes or less
of free disk capacity. If free disk capacity has fallen to 10
minutes or less, you should make more capacity available
by deleting recorded clips before carrying out this
operation.
1
Select the RECEIVE item on the Network menu and
press the k (OUT) button.
The RECEIVE CLIP screen appears, showing the
currently selected source host and the name of the target
clip.
2
If the source host and clip are correct, proceed to step
5.
To select the destination host, execute steps 2 to 4 of
“Sending Clip Data” (page 55).
SEND ADDRESS BOOK
< 01: AAAAAAAA >
HOST: HOST2
SEND : SET KEY
TO MENU : MENU KEY
Transfer destination host
a)
a) "--------" is displayed when no destination host is selected.
Receive
NETWORK MENU
SEND
CLIP
CLIPLIST A/V/TC/CM
ADDRESS BOOK
RECEIVE
ADDRESS BOOK
NEW CONTENTS LIST
STATUS
Time counter display
Monitor screen
RECEIVE CLIP
< 01: AAAAAAAA >
HOST: HOST2
CLIP: 0001
RECEIVE : SET KEY
TO MENU : MENU KEY
Transfer source host
a)
Name of clip to receive
b)
a) “--------” is displayed when no source host is selected.
b) “----” is displayed when no clip is selected.