Sony DSR-DR1000AP DVD Recorder User Manual


 
36
Playback
Chapter 3 Recording and Playback
R and P lit at same time: Output signals are selected by
the R and P buttons in the PANEL SELECT section.
Recording signals are output when the R button is lit,
and playback signals are output when the P button is
lit.
If the REMOTE I/F menu item (see page 69) is set to
9PIN(DUAL), output signals can also be switched from
the device connected to the REMOTE OUT(P) connector.
To switch the time data display
Time data shown in the time counter display and output
from the SUPER connector can be either the data
contained in recording signals or the data in playback
signals. You can select recording or playback data with the
R and P buttons in the PANEL SELECT section.
To select recording signal time data: Press the R button.
To select playback signal time data: Press the P button.
R is displayed before the data in the time counter display
when recording data is being output, and P is displayed
before the data when playback data is being output.
However, when the line output is playback data (the P
indicator in the LINE OUT SELECT section is lit) and
recording data is being displayed in the time counter
display (the R button is lit), R* is displayed before the data
in the time counter display. P* is displayed before the data
in the time counter display when line output is recording
data (the R indicator in the LINE OUT SELECT section is
lit) and playback data is being displayed in the time
counter display (the P button is lit).
To exit simultaneous recording and playback
mode
With the R or P button lit in the PANEL SELECT section,
press the STOP button to stop recording or playback. Press
the R and P buttons so that both buttons go out.
Note
You cannot exit simultaneous recording and playback
mode while performing simultaneous recording and
playback. Press the STOP button to stop recording or
playback. You can then exit the mode by pressing the
buttons in the PANEL SELECT section so that the buttons
go out.
Setting Points A and B for Repeat
Playback
You can conduct repeat playback of certain sections.
You can set the repeat playback start point (point A) and
end point (point B) by using the current position or
inputting time code values.
To repeat seamless playback after setting points A and B,
press the PLAY button when the REMOTE indicator is
off.
Note
When performing repeat playback using points A and B as
the playback start and end points, make sure that the
REPEAT TOP and REPEAT END menu items (see page
61) are set to A POINT and B POINT, respectively.
Setting the current position as start point (point
A) or end point (point B)
1
Under the REPEAT FUNCTION menu item (see
page 61), set REPEAT MODE to ON.
2
While holding down the SET button in the menu/clip
control section, press the K button or the k button.
The time code of the current playback position is set
as point A or point B.
At the same time, “A set” or “B set” appears for 0.5
seconds in the time counter display.
Once set, the point A or point B time code value is held in
the non-volatile memory of the unit until changed. It is not
lost when the unit is powered off.
Notes
When setting point A and B, you can only use time code
values. Even when COUNTER is selected with the
COUNTER SELECT button, you cannot use a CNT
value to set point A or B.
During simultaneous recording and playback, playback
side time code values are registered, even if R (recording
side) is selected in the PANEL SELECT section.
Therefore, before setting the A and B points, you should
select P (playback side) in the PANEL SELECT section.
Inputting time code values for points A and
B
Using the following procedure, you can modify the time
code value for point A or B.
MENU RESET SET
CUE
IN
OUT
MENU RESET SET
CUE
IN OUT
Set the start point
(point A)
Set the end point
(point B)