Filter
Top Products
15
Status Display
System status
The camera model name and signal format are displayed at
the top of the page (a “-” mark is displayed instead when a
camera is not connected).
Reference: Reference signal format and lock status
SDI-1/2: SDI OUTPUT 1/2 connector output format setting
SDI-3/4: SDI OUTPUT 3/4 connector output format setting
Component: Component signal connector output format
setting
CCU hardware diagnostics
The camera Auto Setup category, and the corresponding
setup item and status are displayed at the top of the page.
DPR: DPR board status
AT: AT board status
Front Panel: Front panel status
Camera system diagnostics
Page 1
Multi Type: Multi-core cable transmission mode
Multi Cable: CCU multi-core cable connection status
Multi Comp.: Multi-core cable compensation mode selection
Multi Step: Multi-core cable length display
Fan Power: CCU power supply fan status
Timer: Elapsed time since power-on
CCU Power: CCU power supply status
SerialNo: CCU serial number
Page 2
CAMERA Cable: Camera cable connection status
CAMERA Data: Camera data transmission status
CAMERA Power: Camera power supply status
REMOTE Cable: Remote device cable connection status
REMOTE Data: Remote device data transmission status
REMOTE Power: Remote device power supply status
Page 3
Intercom CCU FRONT: CCU intercom selection
Intercom CAMERA: Camera intercom channel 1 selection
and microphone status
CAM MIC Gain CH1 (FRONT): Amplifier gain for a
microphone connected to the camera AUDIO 1 IN
connector.
CAM MIC Gain CH2 (REAR): Amplifier gain for a microphone
connected to the camera AUDIO 2 IN connector.
Network diagnostics
Page 1
MacAddress: MAC address stored in CCU EEPROM
Auto Negotiation: Auto negotiation setting
Connection Speed: Connection speed setting
Duplex Mode: Communication method setting
Link Status: Network connection status
*System Status* 1/13
HXC-D70 1080/59.94I
Reference:Free Lock
SDI-1/2 :1080/59.94I
SDI-3/4 :525/59.94I
Component:SD YCD
*Diagnosis* 2/13
DPR :OK
AT :OK
Front Panel : OK
*System Diag 2/3* 4/13
CAMERA Cable Connect
Data OK
Power OK
REMOTE Cable Connect
Data OK
Power OK
*System Diag 3/3* 5/13
Intercom
CCU FRONT PROD
MIC ON
CAMERA ENG+PROD
MIC OFF
CAM MIC Gain
CH1(FRONT) 60
dB
CH2(REAR) 60
dB
*Network Diag 1/3* 6/13
MacAddress:000000-000000
Auto Negotiation: ON
Connection Speed:100M
Duplex Mode :HALF
Link Status :OK