Filter
Top Products
Playing Discs in Various Modes
32
GB
Controlling an AV amplifier with the
remote
1 Slide TV/DVD switch to DVD.
2 Hold down 1/u, and enter your AV receiver’s
manufacturer’s code (see the table below) using
the number buttons. Then release 1/u.
Code numbers of controllable receivers
If more than one code number is listed, try entering
them one at a time until you find the one that works
with your receiver.
You can also change the volume of the sound using AV
VOL and AV MUTING.
Note
Depending on the AV receiver, you may not be able to control
your AV receiver.
When you set the TV/DVD switch to TV, you can
control your TV using the keys below.
By pressing
1/u
TV/VIDEO
TV/DVD*
VOL
PROG
WIDE MODE
Number buttons
and ENTER
* If you connect the player to the TV via the EURO AV OUT
connectors, the input source for the TV is set to the player
automatically when you start playback or press any button
except for 1/u. In this case , press TV/DVD to return the
input to the TV.
Notes
• Depending on the TV, you may not be able to control your
TV or to use some buttons above.
• If you use number buttons to select programme position of
the TV, press ? followed by the number buttons for
two-digit numbers.
You can
Turn on or off the TV
Select the input source for the TV
Return the input source for the TV to
the TV
Adjust the volume of the TV
Select the programme position of the
TV
Switch the wide picture mode on or
off
Select the programme position of the
TV
TV/VIDEO
VOL
1/u
Number
buttons
TV/DVD
switch
ENTER
WIDE MODE
PROG/◊/√
?
TV/DVD
Manufacturer
Sony
Denon
Kenwood
Onkyo
Pioneer
Sansui
Technics
Yamaha
Code number
91(default), 88,
89
84, 85, 86
92, 93
81, 82, 83
99
87
97, 98
94, 95, 96
123
456
789
0
AV VOL
AV MUTING
123
456
789
0